Zanussi ZGG67411XA User Manual download pdf (Page 11)

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Electrical connection

• Make sure that the rated voltage and type of

power on the rating plate agree with the

voltage and the power of the local power

supply.

• This appliance is supplied with a mains ca-

ble. It has to be supplied with a correct plug

which can hold the load that the rating plate

rates. Make sure that you install the plug in a

correct socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is

in connection with an extension cable, an

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

Make sure that you connect the blue neutral

cable to the terminal with a letter "N" on it.

Connect the brown (or black) phase cable to

the terminal which has a letter "L". Keep the

phase cable connected at all times.

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make sure

that the cable section is applicable to the volt-

age and the working temperature. The yellow/

green earth wire must be approximately 2 cm

longer than the brown (or black) phase wire.

Building In

min. 55 mm

min. 650 mm

550 mm

min. 100 mm

30 mm

470 mm

A

B

A) supplied seal

B) supplied bracket

Caution! Install the appliance only on a

worktop with flat surface.

Possibilities for insertion

Kitchen unit with door

The panel installed below the hob must be

easy to remove and let an easy access in case

a technical assistance intervention is necessa-

ry.

min 20 mm

(max 150 mm)

30 mm

60 mm

B

A

A) Removable panel

B) Space for connections

11

www.zanussi.com

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments