Zanussi ZGG67411XA User Manual download pdf (Page 6)

Ignition of the burner

Warning! Be very careful when you use

open fire in kitchen environment.

Manufacturer decline any responsibility in case

misuse of the flame

Always light the burner before you put

cookware.

To light the burner:

1. Push and hold the spark generator button

.

2. At the same time turn the control knob

counterclockwise to the maximum position

and push it down to light the burner.

3. Adjust the flame after it is regular.

If after some tries the burner does not

light, check if the crown and its cap are in

correct positions.

A

B

C

A) Burner cap

B) Burner crown

C) Ignition candle

Warning! Do not keep the control knob

pushed for more than 15 seconds.

If the burner does not light after 15 seconds,

release the control knob, turn it into off position

and try to light the burner again after minimum

1 minute.

Important! In the absence of electricity you

can ignite the burner without electrical device;

in this case approach the burner with a flame,

push the relevant knob down and turn it

counter-clockwise to maximum gas release

position.

If the burner accidentally goes out, turn

the control knob to the off position and try

to light the burner again after minimum 1 mi-

nute.

The spark generator can start automatical-

ly when you switch on the mains, after in-

stallation or a power cut. It is normal.

Turning the burner off

To put the flame out, turn the knob to the sym-

bol

.

Warning! Always turn the flame down or

switch it off before you remove the pans

from the burner.

Helpful hints and tips

Warning! Refer to the Safety chapters.

Energy savings

• If possible, always put the lids on the pans.

• When the liquid starts to boil, turn down the

flame to barely simmer the liquid.

Warning! Use cookware with diameters

applicable to the size of burners.

Burner Diameters of cookware

Rapid 180 - 260 mm

Rear left semi-

rapid

120 - 220 mm

Rear right semi-

rapid

120 - 220 mm

6

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments