ENZGH78534User ManualHobDZ LY MA TN
Labels supplied with the accessoriesbagStick the adhesive labels as indicated below:MOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NO.03
A B CA) End of shaft with nutB) WasherC) Elbow (if needed)Liquid gasUse the rubber pipe holder for liquid gas.Always engage the gasket. Then continue
• Make sure that there is an access to themains plug after the installation.• Do not pull the mains cable to disconnectthe appliance. Always pull the
Technical informationHob dimensionsWidth 745 mmDepth 515 mmBypass diametersBURNER Ø BYPASS 1/100 mmTriple Crown 56Semi-rapid 32Auxiliary 28Other techn
BURNER NORMALPOWERkWMINIMUMPOWERkWINJECTORMARK 1/100mmNOMINAL GAS FLOW g/hG30 28-30mbarG31 37 mbarAuxiliary 1,0 0,33 50 73 71Energy efficiencyProduct
www.zanussi.com 15
www.zanussi.com/shop867321497-A-072015
ContentsSafety information 2Safety instructions 3Product description 5Daily use 6Hints and tips 7Care and cleaning 8Troubleshooting 8Installation 10Te
• Unattended cooking on a hob with fat or oil can be dangerousand may result in fire.• Never try to extinguish a fire with water, but switch off theap
• Before carrying out any operation make surethat the appliance is disconnected from thepower supply.• Make sure that the electrical information onthe
• Do not let cookware to boil dry.• Be careful not to let objects or cookware fallon the appliance. The surface can bedamaged.• Do not activate the co
Control knobSymbol Descriptionno gas supply / off positionSymbol Descriptionignition position / maximumgas supplyminimum gas supplyDaily useWARNING!Re
thermocouple warm up. If not, the gassupply is interrupted.3. Adjust the flame after it is regular.If after some tries the burner doesnot light, check
Burner Diameter ofcookware(mm)Triple Crown 180 - 280Semi-rapid (rear left) 120 - 240Semi-rapid (rear right) 120 - 240Burner Diameter ofcookware(mm)Sem
What to do if...Problem Possible cause RemedyThere is no spark when you try toactivate the spark generator.The hob is not connected to anelectrical su
Comments to this Manuals