Zanussi ZGO63414BA User Manual download pdf (Page 26)

A B C

A. End of shaft with nut

B. Washer supplied with the appliance

C. Elbow supplied with the appliance

Liquid gas

Use the rubber pipe holder for liquid gas. Always

engage the gasket. Then continue with the gas

connection.

The flexible pipe is prepared for apply when:

• it can not get hot more than room temperature,

higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting edges or

corners;

• it can be easily examined in order to make sure

its condition.

The control of preservation of the flexible pipe

consists in checking that:

• it does not show cracks, cuts, marks of burnings

on the two ends and on its full length;

• the material is not hardened, but shows its

correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not repair the

pipe, but replace it.

WARNING! When installation is

complete, make sure that the seal of

each pipe fitting is correct. Use a

soapy solution, not a flame!

INJECTORS REPLACEMENT (ONLY FOR

BELGIUM)

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. With a socket spanner 7 remove the injectors

and replace them with the ones which are

necessary for the type of gas you use (see

table in "Technical Data" chapter).

4. Assemble the parts, follow the same procedure

backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type of

gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you must fit

an applicable pressure adjuster on the gas supply

pipe.

ADJUSTMENT OF MINIMUM LEVEL (ONLY

FOR BELGIUM)

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob .

4. With a thin screwdriver, adjust the bypass

screw position (A).

5. If you change:

• from natural gas G20/G25 20/25 mbar to

liquid gas, fully tighten the bypass screw in.

• from liquid gas to natural gas G20/G25

20/25 mbar, undo the bypass screw

approximately 1/4 of a turn.

WARNING! Make sure the flame does

not go out when you quickly turn the

knob from the maximum position to the

minimum position.

ELECTRICAL CONNECTION

• Make sure that the rated voltage and type of

power on the rating plate agree with the voltage

and the power of the local power supply.

• This appliance is supplied with a mains cable. It

has to be supplied with a correct plug which

can hold the load that the rating plate rates.

Make sure that you install the plug in a correct

socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the mains

plug after the installation.

• Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is in

connection with an extension cable, an adapter

or a multiple connection. Make sure that the

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Comments to this Manuals

No comments

Zanussi ZGO63414BA User Manual Page 26

Comments to this Manuals

Related products and manuals for Hobs Zanussi ZGO63414BA