Zanussi ZDE47100W User Manual download pdf (Page 12)

Important! The hot air emitted by the tumble dryer can

reach temperatures of up to 60°C. The appliance must

therefore not be installed on floors which are not resistant

to high temperatures.

When operating the tumble dryer, the room temperature

must not be lower than +5°C and higher than +35°C, as

it may affect the performance of the appliance.

Warning! Should the appliance be moved, it must

be transported vertically.

Warning! The appliance must not be installed

behind alockable door, a sliding door or a door with

a hinge on the opposite side to that of the appliance.

Ensure min. 5cm free space around the appliance.

Removing transport safety packaging

Caution! Before use all parts of the transport

packaging must be removed.

1. Open loading door.

2. Pull off adhesive strips

from inside machine on

top of drum.

3. Remove foil hose and

polystyrene padding from

the machine.

Fitting the vent hose

To simplify the installation, there is a choice of vent out-

lets: one at the back, the others in the left and right-hand

side. Connect the hose to whichever is the more conven-

ient by pulling the ring nut (A) from the vent outlet at the

back, screwing it on to the hose and pushing it firmly back

into place. The unused vents should now be sealed with

the special snap covers provided.

If the hose is long and the

room temperature low, the

moisture might condense to

water inside the hose. This

is an unavoidable natural

phenomenon. To prevent

this water from Iying in the

hose or flowing back into the

tumble dryer, it is advisable

to drill a small hole (via. 3 mm) in the lowest point of the

hose and to place a small container below it. (See picture,

point B).

Once connected to the dryer, run the vent hose to the

desired outlet point, ensuring that the run’s overall length

is less than 2 m, and that it contains no more than two

bends. As to the outlet itself, if you have decided on a

fixed wall/window grille, a good local builder’s merchant

should be able to supply you with the necessary fittings

and installation advice.

Warning!

It is important not to connect

the vent hose to, for

example, a cooker hood, or

a chimney or flue pipe

designed to carry the

exhaust from a fuel burning

appliance.

Note that to avoid conden-

sation problems, it is essential that the dryer be fitted with

the flexible hose to carry its “exhaust” at least beyond the

kitchen units; preferable outside the kitchen. In order to

prevent the appliance from overheating, it is important

that the steam exhaust is unobstructed. Therefore, in case

of a permanent hose fitted to an exterior wall or ceiling, it

must be ensured an exhaust capacity of at least 150 m3/

h. If the dryer is fitted next to kitchen units, make sure that

the vent hose is not squashed. If the hose is partially

squashed, drying efficiency will be reduced, resulting in

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Zanussi ZDE47100W User Manual Page 12

Comments to this Manuals

Related products and manuals for Tumble dryers Zanussi ZDE47100W