Zanussi ZTE170 User Manual download pdf (Page 22)

Adjusting the level of conductivity

Water contains, a variable quantity of limestone

and mineral salts of which quantities vary

according to geographical locations thus varying

its conductivity values.

Relevant variations of the conductivity of the

water compared to those prefixed by the factory

could slightly influence the residual humidity of

the laundry at the end of the cycle.

Your dryer allows you to regulate the sensitivity of

the drying sensor based on conductivity values of

the water by using the following procedure.

To access adjustment mode:

Turn the programme selector dial to switch on the

appliance. In selection mode, press

simultaneously the buttons 2 and 4. Press the

buttons down until the pilot lights above each one

begin to flash and one of the pilot lights indicating

the drying phase lights , , remains lit

Adjusting the level of conductivity:

Press the button Start/Pause sequentially: the

level of conductivity is indicated by the lighting of

the horizontal hyphens.

Normally, the appliance is factory-set to the

highest level; however, certain models may

be configured differently.

Memorizing the new setting:

Simultaneously press the buttons 2 and 4. Press

the buttons down until the pilot lights above each

ones stop flashing and the buzzer sounds.

Display Conductivity

degree

Approximative

value (μS/cm)

Low < 300

Medium 300 - 600

High > 600

125987771 EN_1.qxp 2007-07-13 09:38 Page 22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 57 58

No comments

Zanussi ZTE170 User Manual Page 22