Zanussi FLS 802 User Manual download pdf (Page 20)

Electrical connections

The applicable rules for electrical security

require an adequate earthing. The plug of the

appliance is provided with such a device.

Make sure your socket outlet is provided with an

adequate earthing too.

The manufacturer declines any liability in case of

accidents or incidents should these safety measures

not be observed.

Before plugging the appliance make sure that:

■

The mains of your installation is the same as on the

rating plate of your appliance (the plate is sticked to

the rear of the appliance).

■

The meter, the fuses, the wiring and the socket outlet

can support the max. power absorbed stated on the

rating plate.

■

The socket base and the plug must fit in adequately

without any reducing interposition, multiple outlets

or adapters. If necessary replace the socket outlet by

an adequate one.

■

Should the plug need to be replaced for any reason,

you must connect the green and yellow (earth) wire

to the terminal in the plug which is marked with the

letter «E» or the earth symbol or coloured green

and yellow.

Permanent connection

In the case of permanent connection it is necessary that

you install a double pole switch between the appliance

and the electricity supply (mains), with a minimum gap

of 3 mm between the switch contacts and of a type

suitable for the required load in compliance with the

current electrical regulations.

The switch must not break the yellow and green earth

cable at any point.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

No comments

Zanussi FLS 802 User Manual Page 20