Zanussi TA522 User Manual download pdf (Page 2)

- 2 -

Installation

The floor must be clean and dry, free from floor polish and other

greasy substances, so that the machine does not slide about.

Do not use any grease as lubrification.

Installation on deep pile carpets and floor

coverings with foam backings is not recommended, as the

stability of the machine is no longer guaranteed. If the

installation must be done on a carpetedfloor, the openings

located at the lower part of the back of the appliance must

remain free. These openings ensure a good ventilation of your

applicance. In case of small format tiles, place a standard

rubber mat under the machine.

With sprung floors, in particular wooden plank floors with

yielding floor boards, screw down a waterproof wooden base at

least 15 mm thick, across at least 2 floor boards. Wherever

possible, place the appliance in the corner of the room - there

wooden floors are most secure and least liable to resonance

vibrations.

Never compensate for small unevennesses in the floor by

placing wood, pasteboard or such like.

The front adjustable feet must be blocked after installation of

the appliance by means of the locking nuts.

Water connection

Connect the water inlet hose to a

cold water tap with a 3/4" gas

threaded orifice, after having

inserted the rugger sealing washer

into the hose collar. If the water

connection is made onto new pi-

pes or onto pipes which have not

been used for a long time, it is

advisable to run off a certain

amount of water before connecting the machine.

Place the curved end of the outled hose into a drain pipe having

a height between 70 and 100 cm from floor level or secure it to

a sink or bath tub. Make sure that the drain hose is firmly

secured so that it will not slip out or fall down from its position.

The water should drain freely and, consequently, the drain hose

should not be choked or placed in such a way as to obstruct the

normal water flow. If an extension hose is required, remember

that it might cause a malfunction in the drain pump, particularly

if the extension has a length in excess of 1 meter or if the

diameter of the extension is smaller than the diameter of the

original drain hose.

INSTALLATION

BE CAREFUL : The parts protecting the inner components of the machine during transit are red. They must all be

removed before using your machine for the first time. In order to avoid possible damage to the appliance, it is

indispensable to take away the polystyrene basis, the two red loosened spacers at the back of the applianc and the

polystyrene wedge (follow the instructions of the unpacking sheet). Close imperatively the 2 holes left by the 2 spacers

with the plugs provided with the appliance ; do not forget to put on the central cover.

Electrical connection

Before fitting the plug into the wall socket, check the following

points :

1) The supply voltage of the domestic wiring system does not

fluctuate by more that 10%, plus or minus, from 220-230 V.

2) The meter, the fuses, the supply line and the wall socket are

suitable to carry the maximum load required by the machine

(2,3 kW).

Very important :

The washing machine is provided with a feeding wire with

earth connection: it must be connected to a plug like that

is provided with a good earth connection.

The replacing of the power cord must only be realized by

the After Sales Service.

The manufacturer declines any responsibility where the

previous recommendations are not followed.

Levelling

It is essential that your machine is absolutely level. Raise or

lower the front feet of the machine ; tighten the nuts of the feet

with an adjustable wrench.

Also make sure that the machine does not touch the wall, the

furnitures, etc. during the functioning in order to avoid vibra-

tions, noise or displacements of the appliance during operation.

Moving of the appliance

To move your washing machine, put it on its wheels by turning

from the right to the left the special level located at the bottom

of the appliance. Once the machine placed at the chosen

place, bring back the lever to its initial position.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Zanussi TA522 User Manual Page 2

Comments to this Manuals

Related products and manuals for Washing machines Zanussi TA522