Zanussi WD15INPUT User Manual download pdf (Page 12)

42

9 TIME TO FINISH display

This display provides the following information:

- Three flashing dashes

appear immediately after pressing the

ON/OFF button and indicate that the machine

is ready to receive instructions for the

required programme;

- Duration of the selected wash programme,

calculated automatically on the basis of the

maximum recommended load for each type

of fabric. The figures on the display flash until

the machine is started with the START

button.

After the programme has started, the time

remaining is updated every 10 minutes, and

every 5 minutes during the last 20 minutes.

About 20 minutes after the programme has

started, the time remaining is updated on the

basis of the actual load size being washed

(cottons only).

When the programme has finished, after the

door lock has released, three flashing zeros

are displayed.

- Delayed start, programmed using the special

button (11).

The selected delay (19 hours max.) is

indicated in the display. The countdown is

updated every hour, and every 5 minutes

during the last hour.

- PAUSE: when the START/PAUSE is pressed

while a wash programme is running, the

figures in the display, which indicate the

time remaining, start to flash.

- Machine heating phase. A dot to the right of

the figures in the display indicates that the

machine is heating the water.

- Incorrect option selection. If an option

which is not compatible with the set wash

programme is selected, the message Err is

displayed.

- Alarm codes. In the event of operating

problems, a specific code appears on the

display (see ÒSomething not workingÓ).

10 START/PAUSE button

This button has three functions:

a) Start

After having selected the required

programme, press this button to start the

machine; the display stops flashing.

b) Pause

To interrupt a wash programme which is

running, press the START/PAUSE button: the

figures displayed will start to flash.

The drying programme cannot be

interrupted.

To restart the programme from the point at

which it was interrupted, press the

START/PAUSE button again.

c) Empty out water

At the end of a programme which stops with

water in the drum (RINSE HOLD option), or

after the soak programme, press the

START/PAUSE button to empty out the

water: after a soak programme, the machine

will empty only; after RINSE HOLD

programmes, the machine will empty and

spin.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Comments to this Manuals

No comments