ENUser manualWasher DryerZKG 7125ZKG 7145ZKG 7165
Programme - Maximum and Minimum Temperature- Cycle Description - Maximum Spin Speed - Maxi-mum Fabrics Load - Type of LaundryOptionsDetergent Com-part
Programme - Maximum and Minimum Temperature- Cycle Description - Maximum Spin Speed - Maxi-mum Fabrics Load - Type of LaundryOptionsDetergent Com-part
Drying ProgrammesDegree of Drying Type of Fabric Max Load Spin SpeedSuggesteddrying timein MinsSuitable for items to put awaywithout ironingCotton and
Dried grease stains: moisten with turpentine,lay the garment on a soft surface and dab thestain with the fingertips and a cotton cloth.Rust: oxalic ac
Drying HintsPreparing the drying cycleAs a dryer, the appliance works on the conden-sation principle.Therefore, the water tap must be openand the drai
laundry in the machine, to remove anymanufacturing residue from the drumand tub. Pour 1/2 a measure of deter-gent into the main wash compartmentand st
Select the required programme by meansof the programme selector dial (1)Turn the programme selector dial to the re-quired programme.The green pilot li
Important! • The selected delay can be changed only af-ter selecting the washing programme again.• The door will be locked throughout the delaytime. I
Note! By pressing Drying Time button it isalso possible to dry up to 4 kg of cottonitems (see the «Drying Programme» table).The water tap must be open
the display. At this point of the programme,starts an anti-crease phase which lastsabout 10 minutes. During this time thedoor is locked and the displa
ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _ _ _ _ _ _ _ _ _
Replace the drawer and run the rinse pro-gramme without any clothes in the drum.Cleaning the pumpThe pump should be inspected regularly andparticularl
21Clean the filter under the water tap and put itback in the pump into the special guides.Make sure that you tighten correctly the filterto prevent le
4. put the two ends of the inlet hose in a con-tainer and let the water flow out of thehose.5. empty the drain pump as described in the‘Emergency empt
Problem Possible cause/SolutionThe washing machine doesnot start:The door has not been closed. • Close the door firmly.The plug is not properly insert
Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent (creates too much foam)has been used.• Reduce th
Problem Possible cause/SolutionThe machine makes an un-usual noise:The machine is fitted with a type of motor which makes an unusual noisecompared wit
Electrical connectionVoltage - Overall power - FuseInformation on the electrical connection is given on the rating plate, onthe inner edge of the appl
After removing all thepackaging, carefullylay machine on it'sback to remove thepolystyrene basefrom the bottom.Remove the powersupply cable and t
• Connect the ap-propriate end ofthe hose to a tapwith a 3/4” thread.Always use thehose supplied withthe appliance.35°45°• Connect the other end of th
Min. 60 cm (23.6”)Max. 90 cm (35.4”)If your drain hoselooks like this (seebeside) you do notrequire the “U”piece”. Just push thehose firmly in to thes
• Do not change the specification of this appliance.• Obey the maximum load volume of 8 kg (refer to the “Programmechart” chapter).• If the supply cor
household waste disposal service or the shopwhere you purchased the product.Packaging materialsThe materials marked with the symbol arerecyclable.>
31www.zanussi.com
www.zanussi.com/shop 132937921-A-432012
change the fuse in the mains plug, use a 13amp ASTA (BS 1362) fuse.•This appliance complies with the E.E.C. Di-rectives.Water connection• Make sure no
Warning! Risk of injury or suffocation.• Disconnect the appliance from the mainssupply.• Cut off the mains cable and discard it.• Remove the door catc
Compartment for liquid additives (fabric softener, starch).Follow the product manufacturer’s recommendations on quantities to use and do not exceed t
7Start/Pause button8Delay start button9Door pilot light10DisplayTable of symbols= Rinse hold = Child Safety Lock1-8 Programme selector dial, spin spee
10 Display10.1 10.2The display shows the following information:10.1 Child safety lockThis device permits you to leave the appliance unattended during
Washing ProgrammesProgramme - Maximum and Minimum Temperature- Cycle Description - Maximum Spin Speed - Maxi-mum Fabrics Load - Type of LaundryOptions
Comments to this Manuals