Zanussi ZWD1261 User Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
brightness of the display is reduced. By pressing any
button the appliance will come out of the energy saving
status.
Use - Drying
Drying only
The recommended load size is 4 kg for cottons and linen,
and 3 kg for synthetic items.
Note! By pressing Drying Time button it is also possible
to dry up to 6 kg of cotton items (see the «Drying Pro-
gramme» table).
The water tap must be open and the drain hose must be
positioned in the sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin speed al-
lowed for the type of laundry in order to obtain the
best drying performances.
3. Select the drying programme for Cottons or Synthetic
in the Drying sector of the programme selector dial.
4. If you wish to select an electronic drying, press the
button 3 until the pilot light corresponding to the re-
quired dryness degree illuminates.
5. If you wish to select a timed drying, press button 4
until the time you want appears on the display (see
the «Drying Programmes» table). Every time you
press this button the drying time increases by 5 mi-
nutes.
Note!
The programme time will automatically increase by a
few minutes.
6. Press button 7 to start the programme.
After the programme has started, the time remaining
is updated every minute.
Note!
The different type of cottons (towelling, sheets, shirts,
and so on) or any laundry items rolling up during the
spinning phase may result in partial dryness. In the
exceptional case that at the end of the cycle the laun-
dry remains slightly wet, we suggest that you unfold
the rolled up items, redistribute them evenly in the
drum and select an additional drying cycle of 20-30
minutes.
7. At the end of the programme, the buzzer sounds and
a blinking «
» appear on the display.
The last 10 minutes of the drying cycle correspond
to an anti-crease phase. During this time the door is
locked and the display keeps showing the flashing
zero «
».
Note!
If you wish to open the door before or during the anti-
crease phase or to interrupt it, press any button or
turn the programme selector dial to any programme
position (except
), the door can be opened after
a few minutes.
8.
Turn the selector dial to the
position to switch
the machine off.
9. Remove the laundry.
Automatic washing and drying (NON-STOP programme)
For NON-STOP programmes, the recommended load size
is 4 kg for cotton and 3 kg for synthetic.
Note! It is possible to dry up to 6 kg of cotton items by
pressing Drying Time button only (see the «Drying Pro-
gramme» table).
Do not use a dosing device/ball when carrying out a
washing and drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the selector dial to
the selected washing programme/fabric.
4. Select the required options by pressing the relevant
buttons.
Note!
If possible, do not select a spin speed lower than that
proposed by the appliance to avoid too long a drying
time therefore saving energy.
In any case the reduction of the spin speed is only
possible after selecting drying.
5. Select the drying time by pressing the button 4 or
dryness degree by pressing the button 3 . The display
shows the entire duration of the washing and the se-
lected drying cycle.
15
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments