Zanussi ZWF81663W User Manual download pdf (Page 15)

Frost precautions

If the appliance is installed in an area where the

temperature can be less than 0 °C, remove the

remaining water from the inlet hose and the

drain pump.

Do this procedure also when you

want to do the emergency drain.

1. Disconnect the mains plug from the mains

socket.

2. Remove the water inlet hose.

3. Remove the drain hose from the rear

support and unhook it from sink or spigot.

4. Put the ends of the drain and inlet hose in a

container. Let the water flow out of the

hoses.

5. When no more water flows, install the inlet

hose and the drain hose again.

WARNING!

Make sure that the temperature is

more than 0 °C before you use the

appliance again. The manufacturer is

not responsible for damages caused

by low temperatures.

Troubleshooting

WARNING!

Refer to Safety chapters.

Introduction

The start of the appliance does not occur or it

stops during operation.

First try to find a solution to the problem (refer

to the table). If not, contact the Authorised

Service Centre.

With some problems, the acoustic signals

operate and the display shows an alarm

code:

•

- The appliance does not fill with water

properly.

• - The appliance does not drain the

water.

• - The appliance door is open or not

closed correctly. Please check the door!

If the appliance is overloaded,

remove some items from the

drum and/or keep pressed the

door and push the button at

the same time until the indicator

stops flashing (see the

picture below).

• - The mains supply is unstable. Wait

until the mains supply is stable.

• - No communication between

electronic elements of the appliance. Switch

off and switch on again.

WARNING!

Deactivate the appliance before you

do the checks.

www.zanussi.com 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments