Zanussi ZWH7149P User Manual download pdf (Page 9)

Water inlet

Connect the hose to

a tap with a 3/4”

thread.

35°

45°

Loosen the ring nut to angle the hose to the

left or right depending on the position of your

water tap. Do not place the inlet hose

downwards. After positioning the inlet hose,

be sure to tighten the ring nut again to prevent

leaks.

Water drainage

Firstly form a hook in the end of the drain hose

using the plastic hose guide supplied with the

appliance .

The end of the drain hose can be positioned

in four ways:

• Hooked over the edge of a sink using

the plastic hose guide.

Tie the plastic hose guide to the tap with a

string to prevent that the drain hose unhooks

when the appliance is emptying.

• Onto a sink outlet spigot.

Push the drain hose onto the spigot and se-

cure with a clip, ensure a loop is formed in the

drain hose to prevent waste from the sink en-

tering the appliance.

If the outlet spigot has not been used before,

remove any blanking plug that may be in

place.

• Directly into a drain pipe at a height of

not less than 60 cm and not more than 100

cm.

MAX 100cm

The end of the drain

hose must always be

ventilated, i.e. the in-

side diameter of the

drain pipe must be

larger than the out-

side diameter of the

drain hose. The drain

hose must not be

kinked.

9

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments