Zanussi ZWI71000WA User Manual download pdf (Page 19)

Positioning

Install the machine on a flat hard floor. Make sure that air

circulation around the machine is not impeded by carpets,

rugs etc. Check that the machine does not touch the wall

or other kitchen units.

Level the washing ma-

chine by raising or lower-

ing the feet. The feet may

be tight to adjust as they

incorporate a self locking

nut, but the machine

MUST be level and stable.

If necessary, check the

setting with a spirit level.

Any necessary adjustment

can be made with a span-

ner.

Accurate levelling prevents vibration, noise and displace-

ment of the machine during operation.

Caution! Never place cardboard, wood or similar

materials under the machine to compensate for any

unevenness in the floor. After having levelled the

appliance, tighten the lock nuts.

Raising the appliance

Suspended wooden floors are particularly susceptible to

vibration.

To help prevent vibration we recommend you place a wa-

terproof wood panel, at least 15 mm thick under the appli-

ance, secured to at least 2 floor beams with screws, the

wood panel must extend beyond the front feet.

If possible install the appliance in one of the corners of

the room, where the floor is more stable.

Water inlet

Warning! This appliance must be connected to a

cold water supply

Caution! Before connecting up the appliance to new

pipework or to pipework that has not been used for

some time, run off a reasonable amount of water to flush

out any debris that may have collected

Caution! Do not use the hose from your previous

appliance to connect to water supply.

Connect the hose to a tap

with a 3/4” thread. Always

use the hose supplied with

the appliance.

35°

45°

The other end of the inlet hose which connects to the

appliance can be turned as showed in the picture.

Do not place the inlet hose downwards. Angle the hose

to the left or right depending on the position of your

water tap. Set the hose correctly by loosening the ring

nut. After positioning the inlet hose, be sure to tighten

the ring nut again to prevent leaks.

Caution! The inlet hose must not be lengthened. If it

is too short and you do not wish to move the tap,

you will have to purchase a new, longer hose specially

designed for this type of use.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a

sink using the plastic hose

guide supplied with the

machine.

In this case, make sure the end cannot come unhooked

when the machine is emptying. This could be done by

tying it to the tap with a piece of string or attaching it to

the wall.

www.zanussi.com

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Comments to this Manuals

No comments

Zanussi ZWI71000WA User Manual Page 19

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWI71000WA