Zanussi ZWI71211WA User Manual

ENUser manualWashing MachineZWI 71211 WA

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartment19 – Abpumpen

Programmes Load(kg)Energy con-sumption(kWh)Water con-sumption (litre)Approximateprogramme du-ration (mi-nutes)Remainingmoisture(%)1)Wool/Hand wash30 °

Red wine: soak in water and detergent, rinseand treat with acetic or citric acid, then rinse.Treat any residual marks with bleach.Ink: depending on th

PersonalisationAcoustic signalsThe machine is provided with an acoustic de-vice, which sounds in the following cases:• at the end of the cycle• if the

The green pilot light of button 7 starts to flash.The selector dial can be turned either clockwiseor anticlockwise.Turn the selector dial to position

Important! The Delay Start cannot beselected with the draining programme.Altering an option or a runningprogrammeIt is possible to change some options

ening powder manufacturer's instructions. Thiswill help to prevent the formation of lime depos-its.External cleaningClean the exterior cabinet of

Put the cap back onthe emergency emp-tying hose and placethe latter back in itsseat.Replace the filter intothe pump by insertingit correctly into thes

• if necessary, wait until the water has cooleddown;• open the pump door;• place a bowl on the floor and place the endof the emergency emptying hose i

Problem Possible cause/SolutionThe machine does not fill:The water tap is closed. • Open the water tap.The inlet hose is squashed or kinked. • Check t

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _ _ _ _ _ _ _ _

Problem Possible cause/SolutionThe machine vibrates is noisy:The transit bolts and packing have not been removed.• Check the correct installation of t

Water supply 1) Cold waterMaximum Load Cotton 7 kgSpin Speed Maximum 1200 rpm1) Connect the water inlet hose to a water tap with a 3/4'' th

If necessary, checkthe setting with a spi-rit level.Rubber feet kit (4055126249)Available from your authorized dealer.The rubber feet are particularly

Water-stop deviceAThe inlet hose is provided with a water stopdevice, which protects against damagecaused by water leaks in the hose whichcould develo

Caution! Connect the machine to anearthed socket.Caution! The manufacturer does notaccept any responsibility for damageor injury through failure to co

C16-22595-59822±1,5416BC35 Ø 12,5-14 depth• a) DoorThe dimensions of the door should be:- width 595-598 mm- thickness 16-22 mmThe height (C-Fig. C) de

If the door has to be opened from left to right,invert the position of the plates (7), the mag-net (4) and the plate (5) (Fig. B and E). Mountthe coun

27www.zanussi.com

www.zanussi.com/shop 132918173-A-262014

• Do not change the specification of this appliance.• Obey the maximum load volume of 7 kg (refer to the “Programmechart” chapter).• If the supply cor

Water connection• Make sure not to cause damage to the waterhoses.• The appliance is to be connected to the wa-ter mains using the new supplied hose-s

To activate this de-vice, rotate the button(without pressing it)inside the door clock-wise until the grooveis horizontal. If neces-sary use a coin.To

1 32 4 5 6 791081Programme selector dial2Spin reduction button (Schleudern)3Options button (Optionen)4Prewash button (Vorwäsche)5Easy Iron button (Büg

lergic to detergents, and in areas where the wa-ter is very soft.Start PauseThis button allows you to start or to interrupt theselected programme.Dela

Washing programmesProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompar

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartment14 – Jeans at