Zanussi ZWP581 User Manual download pdf (Page 10)

Precautions to be taken against frost

If your appliance is exposed to temperatures

below 0°C, the following precautions must be

taken:

• Close the tap and disconnect the inlet hose.

• Place the end of this hose and the drain hose

in a basin on the floor.

• Select the Drain programme let it run until

the end of the cycle.

• Disconnect the appliance from the power

supply by turning the programme selector to

“Stop”

• Unplug the appliance.

• Replace the inlet hose and drain hose.

This way, the water remaining in the hoses will

be drained away, avoiding any ice formation

which would damage your appliance.

Before turning your appliance on again, ensure

that it is installed in an area where the tempera-

ture will not fall below freezing.

NOTE ! This machine is made for use in normal

inside temperature. Manufacturer is not respon-

sible for freezing damages.

Operating Problems

Numerous checks were carried out on your ap-

pliance before it left the factory. However,

should you notice a malfunction, please refer to

the sections below before contacting the after-

sales service.

Problems Causes

The appliance doesn’t start

or doesn’t fill:

• the appliance isn’t plugged in correctly, the electrical installation isn’t work-

ing, there is a power failure,

• the lid of your appliance and the drum shutters aren’t closed firmly,

• the programme start command hasn’t been properly selected,

• the water supply has been cut off, the water inlet tap is closed,

• the water inlet filters are dirty (see “Care and cleaning ”).

The appliance fills but

empties straight away:

• the drainage U-piece is fixed too low (see “Installation”).

The appliance doesn’t

rinse or doesn’t empty:

• the drain hose is blocked or bent,

• the drainage filter is obstructed (see “Care and cleaning ”),

• the out of balance detector has been activated: washing is unevenly distrib-

uted in the drum,

• the “Drain” programme or “Night Cycle” or “Rinse hold” option have been

selected,

• the height of the drainage U-piece is unsuitable.

The appliance doesn’t

spin:

• balance problem with the laundry load: add more laundry or manually adjust

the items in the drum.

You have found water

around the appliance:

• too much detergent has caused foam to overflow,

• the detergent is unsuitable for machine washing,

• the drainage U-piece isn’t attached correctly,

• the water inlet hose is leaking.

www.zanussi.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Zanussi ZWP581 User Manual Page 10

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWP581