Zanussi ZDI6503X User Manual

GETTING STARTED?EASY.User ManualZDI6503XEN User ManualDishwasher

STARTING A PROGRAMMEOpen the water tap, close the door, select a programme, press Start .OPTION DELAYWith this option you can postpone the start of a

AT THE END OF THE PROGRAMME5 minThe indicator comes on. If you do not deactivate the appliance within 5 minutes all indicators goes off.This helps t

the tableware, we recommend that you use thetablets with long programmes.• Do not use more than the correct quantity ofdetergent. Refer to the instruc

C• Make sure that there are no residues of food or soil in or around the edge of the sump.• Put back in place the flat filter (C). Make sure that it i

Problem and alarm code Possible cause and solutionYou cannot activate the appliance. • Make sure that the mains plug is connected to themains socket.•

Problem and alarm code Possible cause and solutionThe appliance trips the circuit-beaker. • The amperage is insufficient to supply simultaneous-ly all

Problem Possible cause and solutionThe interior of the appliance iswet.• This is not a defect of the appliance. it is caused by the hu-midity in the a

Capacity Place settings 13Power consumption Left-on mode (W) 5.0Power consumption Off-mode (W) 0.501) Refer to the rating plate for other values.2) If

ENVIRONMENTAL CONCERNSRecycle the materials with the symbol . Put thepackaging in applicable containers to recycle it.Help protect the environment an

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP156905520-A-092016

• Do not keep the appliance door open without supervision toprevent to fall on it.• Before any maintenance operation, deactivate the applianceand disc

• Dishwasher detergents are dangerous. Obeythe safety instructions on the detergentpackaging.• Do not drink and play with the water in theappliance.•

EASY START1 2 34561On/off indicator2Programme marker3Indicators4Delay button5Start button6Programme knobINDICATORSWashing phase. It comes on when the

PROGRAMMESProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Duration(min)Energy(kWh)Water(l) 2)Normal soilCrockery andcutlery• Pr

Do not use detergent and do not load thebaskets.THE WATER HARDNESS TABLEGerman degrees(°dH)French degrees(°fH)mmol/l Clarke degreesWater softenerlevel

• Release when and start to flash.• Press . Indicators , and flash. The current setting is indicated by the intermittent flashingof the

ADDING DETERGENT212030ABIf the programme has a prewash phase, put a small quantity of detergent also in compartment B.ADDING MULTI-TABLETS212030• Do n