Zanussi ZFC21400WA User Manual download pdf (Page 10)

Replacing the lamp

WARNING!

Do not remove the lamp cover at the

time of replacement. Do not operate

the freezer if the lamp cover is

damaged or missing.

1. Disconnect the mains plug from the mains

socket.

2. Replace the used lamp with a new lamp of

the same power and specifically designed

for household appliances (the maximum

power is shown on the lamp cover).

3. Connect the mains plug to the mains

socket.

4. Open the lid. Make sure that the lamp

comes on.

Installation

WARNING!

Refer to Safety chapters.

Positioning

CAUTION!

If you are discarding an old

appliance that has a lock or catch on

the lid, you must ensure that it is

made unusable to prevent young

children being trapped inside.

This appliance can be installed in a dry, well

ventilated indoor where the ambient

temperature corresponds to the climate class

indicated on the rating plate of the appliance:

Climate

class

Ambient temperature

SN +10°C to + 32°C

N +16°C to + 32°C

ST +16°C to + 38°C

T +16°C to + 43°C

Some functional problems might

occur for some types of models

when operating outside of that

range. The correct operation can

only be guaranteed within the

specified temperature range. If you

have any doubts regarding where to

install the appliance, please turn to

the vendor, to our customer service

or to the nearest Service Centre

The appliance shall have the plug

accessible after installation.

Electrical connection

• Before plugging in, ensure that the voltage

and frequency shown on the rating plate

correspond to your domestic power supply.

• The appliance must be earthed. The power

supply cable plug is provided with a contact

for this purpose. If the domestic power

supply socket is not earthed, connect the

appliance to a separate earth in compliance

with current regulations, consulting a

qualified electrician.

• The manufacturer declines all responsibility if

the above safety precautions are not

observed.

• This appliance complies with the E.E.C.

Directives.

Ventilation requirements

The airflow behind the appliance must be

sufficient.

1. Put the freezer in horizontal position on a

firm surface. The cabinet must be on all four

feet.

2. Make sure that the clearance between the

appliance and rear wall is 5 cm.

3. Make sure that the clearance between the

appliance and the sides is 5 cm.

10 www.zanussi.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Comments to this Manuals

No comments