Zanussi ZFT710W Basic Guide download pdf (Page 13)

• Make sure that the mains plug is accessible after the

installation of the appliance.

•

Connect to potable water supply only.

Service

• Any electrical work required to do the servicing of the

appliance should be carried out by a qualified electri-

cian or competent person.

• This product must be serviced by an authorized Service

Centre, and only genuine spare parts must be used.

Environment Protection

This appliance does not contain gasses which could

damage the ozone layer, in either its refrigerant cir-

cuit or insulation materials. The appliance shall not be

discarded together with the urban refuse and rubbish. The

insulation foam contains flammable gases: the appliance

shall be disposed according to the applicable regulations

to obtain from your local authorities. Avoid damaging the

cooling unit, especially at the rear near the heat exchang-

er. The materials used on this appliance marked by the

symbol

are recyclable.

Control panel

1 2 3 4 5

1 Green Indicator Light

2 Red Indicator Light

3 Yellow Indicator Light

4 Freezer Switch

5 Temperature Regulator

Switching on

1. Allow the appliance to stand for 4 hrs after installa-

tion.

2. Insert the plug into the wall socket.

3. Turn the Temperature Regulator clockwise to a me-

dium setting.

4. The Green Indicator Light will light up and remain lit

until the appliance is switched off at the mains.

5. Press the Freezer Switch to activate the fast-freeze

function (Yellow Indicator Light will illuminate) and

leave to run for 4 hours to allow the correct temper-

ature to be reached before placing food inside.

Yellow Indicator Light lights in the switched-on state

of the Freezer Switch.

6. The Red Indicator Light will also illuminate until the

correct temperature is reached.

A few hours after starting up the Red Indicator Light

will go out to show that the correct temperature has

been reached for the setting chosen and will stay out

to indicate that everything is in order. It will come on

if the freezer temperature rises unduly for instance,

after opening the freezer door or placing food inside

the cabinet, but the light should go out again when

the temperature returns to the correct storage level.

7. When the appliance has reached the set temperature

(the Red Indicator Light has gone out) press the

Freezer Switch again to switch off the fast freeze func-

tion. The Yellow Indicator Light will go out.

Switching off

1. To turn off the appliance, turn the Temperature Reg-

ulator to the "O" position.

6) If a water connection is foreseen

1 ... 12 13 14 ... 40

Comments to this Manuals

No comments

Zanussi ZFT710W Basic Guide Page 13

Comments to this Manuals

Related products and manuals for Freezers Zanussi ZFT710W