Zanussi ZRB934PX2 User Manual download pdf (Page 34)

must therefore only be carried out by authorized

technicians.

Periodic cleaning

The equipment has to be cleaned regularly:

• clean the inside and accessories with luke-

warm water and some neutral soap.

• regularly check the door seals and wipe clean

to ensure they are clean and free from debris.

• rinse and dry thoroughly.

Important! Do not pull, move or damage any

pipes and/or cables inside the cabinet.

Never use detergents, abrasive powders, highly

perfumed cleaning products or wax polishes to

clean the interior as this will damage the surface

and leave a strong odour.

Clean the condenser (black grill) and the com-

pressor at the back of the appliance with a

brush. This operation will improve the perform-

ance of the appliance and save electricity con-

sumption.

Important! Take care of not to damage the

cooling system.

Many proprietary kitchen surface cleaners con-

tain chemicals that can attack/damage the plas-

tics used in this appliance. For this reason it is

recommended that the outer casing of this ap-

pliance is only cleaned with warm water with a

little washing-up liquid added.

After cleaning, reconnect the equipment to the

mains supply.

Defrosting of the refrigerator

Frost is automatically eliminated from the evapo-

rator of the refrigerator compartment every time

the motor compressor stops, during normal use.

The defrost water drains out through a trough

into a special container at the back of the appli-

ance, over the motor compressor, where it

evaporates.

It is important to periodically clean the defrost

water drain hole in the middle of the refrigerator

compartment channel to prevent the water over-

flowing and dripping onto the food inside. Use

the special cleaner provided, which you will find

already inserted into the drain hole.

Defrosting the freezer

A certain amount of frost will always form on the

freezer shelves and around the top compart-

ment.

Defrost the freezer when the frost layer reaches

a thickness of about 3-5 mm.

To remove the frost, follow the instructions be-

low:

• pull out the plug from the wall socket or

switch off the appliance

• remove any stored food, wrap it in several lay-

ers of newspaper and put it in a cool place

• remove the freezer drawers

• put insulating material around the drawers,

e.g. blankets or newspapers.

Defrosting can be accelerated by placing bowls

with hot water (not boiling) inside the freezer.

• Loosen the drainage channel from its resting

position, push it in according to the illustra-

tion and place it in the bottom freezer drawer

where water can collect

• carefully scrape off the ice when it starts to

thaw. Use a wood or a plastic scraper

• when all the ice has melted, clean and wipe

the cabinet dry, then put the drainage chan-

nel back in place.

• switch on the cabinet and replace the frozen

foodstuff.

It is recommended to operate the appli-

ance at the highest position of the ther-

www.zanussi.com

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

Comments to this Manuals

No comments

Zanussi ZRB934PX2 User Manual Page 34

Comments to this Manuals

Related products and manuals for Fridge-freezers Zanussi ZRB934PX2