Zanussi ZTB271 User Manual download pdf (Page 22)

Changing programme

To change a programme which has been selected by mis-

take once the programme has started, first turn the pro-

gramme selector to "O" - (OFF) position. The programme

is cancelled.

The programme can no longer be changed directly

once the programme has started. If nevertheless

there is an attempt to change the programme on the pro-

gramme knob or if an function button (excluding the

BUZZER button

) is pressed, led on the START PAUSE

button starts flashing temporarily in red. The drying pro-

gramme is not however affected by this (laundry protec-

tion).

Drying cycle complete / removing laundry

Once the drying cycle is complete, the lights END/ANTI-

CREASE and light 5 - FILTER are on. If the buzzer is active,

an acoustic signal sounds intermittently for about one

minute.

The drying cycles are automatically followed by an

anti-crease phase which lasts around 30 minutes.

The drum rotates at intervals during this phase. This keeps

the laundry loose and free of creases. The laundry can be

removed at any time during the anti-crease phase. (The

laundry should be taken out towards the end of the anti-

crease phase at the latest to prevent creases from form-

ing.)

1. Open door.

2. Remove laundry.

3. Remove filter after clothes has been removed. Clean

the filter.

Warning! Before You place the filter , please check

it there is nothing inside the filter seat.

4. Turn the programme selector to OFF.

Important! Clean the filter after each drying cycle.

5. Close the door.

Care and cleaning

Cleaning fluff filter

The filter collect all the fluff which accumulates during

drying. To ensure that the dryer works perfectly, the fluff

filter must be cleaned after every drying cycle.

The warning light FILTER , is on to remind you this op-

eration.

Caution! Never operate the dryer without fluff filter

or with damaged or blocked fluff filter.

1. Open loading door

and remove laun-

dry.

2. Remove the filter

which is built into

the lower part of the

loading aperture.

3. Open the filter

pressing the but-

ton, among two

slots on fingers.

Clean the filter us-

ing dump hand or

cloth. After a period

of time, a patina

due to detergent

residue on laundry forms on the filters. When this

occurs, clean the filter with warm water using a brush.

Close the filter and do not forget to put it back.

Warning! Before You place the filter, please check

it there is nothing inside the filter seat.

4. The filter can be positioned only to one side. If po-

sition is wrong, the filter overhangs.

If the filter will not snap into place, the loading door

cannot be closed.

Warning! You must DISCONNECT the appliance

from the electricity supply, before you can carry out

any cleaning or maintenance work.

4) Only dryers with buzzer button

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments

Zanussi ZTB271 User Manual Page 22

Comments to this Manuals

Related products and manuals for Tumble dryers Zanussi ZTB271