Zanussi ZWF 14070W1 User Manual download pdf (Page 24)

Installation instruction

Transit security bars

Before using the appliance, all transit bolts and

spacers must be removed. You are advised to

keep all transit devices in case the appliance

has to be transported again. Proceed as

follows:

1. Unscrew and remove the three rear screws

using a suitable spanner.

Make sure the hoses are not squashed.

2. Open the porthole and remove the

polystyrene block fitted with adhesive tape

on the door seal.

3. Place the machine in an upright position

and remove the three plastic bolts.

4. Plug the 3 holes with the plastic plugs which

you can find in the envelope containing the

instruction booklet.

Positioning

Install the machine on a flat hard floor. Make

sure that air circulation around the machine is

not impeded by carpets, rugs etc. Check that

the machine does not touch the wall or other

kitchen units. Level the washing machine by

raising or lowering the feet. Once in the right

position fix the feet by pushing the nuts against

the base of the case. The feet may be tight to

adjust as they incorporate but the machine

MUST be level and stable.

If necessary, check the setting with a spirit level.

Accurate levelling prevents vibration, noise and

displacement of the machine during

operation.Never place cardboard, wood or

similar materials under the machine to

compensate for any unevenness in the floor.

Some vibration is inevitable, especially if

mounted on a wooden floor.

Sprung wooden floors are particularly

susceptible to vibration. For advice, consult a

builder.

126.2936.42…ZWF10070-12070-14070.qxd 14/7/08 12:59 Página 24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Zanussi ZWF 14070W1 User Manual Page 24