Zanussi ZWH7148P User Manual download pdf (Page 3)

• Obey the maximum load volume of 7 kg (refer to the “Programme

chart” chapter).

• If the supply cord is damaged, it must be replaced by the manu-

facturer, its service agent or similarly qualified persons in order to

avoid a hazard.

• The operating water pressure (minimum and maximum) must be

between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa)

• The ventilation openings in the base (if applicable) must not be

obstructed by a carpet.

• The appliance is to be connected to the water mains using the

new supplied hose-sets. Old hose sets must not be reused.

Safety instructions

Installation

• Remove all the packaging and the transit

bolts.

• Keep the transit bolts. When you move the

appliance again you must block the drum.

• Do not install or use a damaged appliance.

• Do not install or use the appliance where the

temperature is less than 0 °C or where it is

exposed to the weather.

• Obey the installation instruction supplied

with the appliance.

• Make sure that the floor where you install the

appliance is flat, stable, heat resistant and

clean.

• Do not install the appliance where the appli-

ance door can not be fully opened.

• Always be careful when you move the appli-

ance because it is heavy. Always wear safety

gloves.

• Make sure that there is air circulation be-

tween the appliance and the floor.

• Adjust the feet to have the necessary space

between the appliance and the carpet.

Electrical connection

Warning! Risk of fire and electrical

shock.

• The appliance must be earthed.

• Make sure that the electrical information on

the rating plate agrees with the power sup-

ply. If not, contact an electrician.

• Always use a correctly installed shockproof

socket.

• Do not use multi-plug adapters and exten-

sion cables.

• Make sure not to cause damage to the

mains plug and to the mains cable. Contact

the Service or an electrician to change a

damaged mains cable.

• Connect the mains plug to the mains socket

only at the end of the installation. Make sure

that there is access to the mains plug after

the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• Do not touch the mains cable or the mains

plug with wet hands.

• This appliance complies with the E.E.C. Di-

rectives.

Water connection

• Make sure not to cause damage to the water

hoses.

www.zanussi.com

1 2 3 4 ... 32

Comments to this Manuals

No comments

Zanussi ZWH7148P User Manual Page 3

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWH7148P