Zanussi ZWI71201WA User Manual

ENUser manualWashing MachineZWI 71201 WA

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSPIN Drain an

Ball point pen and glue: moisten with acetone1), lay thegarment on a soft cloth and dab the stain.Lipstick: moisten with acetone as above, then treat

PersonalisationAcoustic signalsThe machine is provided with an acoustic device, whichsounds in the following cases:• at the end of the cycle• if there

Select the spin speed by pressing button 2When selecting a programme, the appliance proposes au-tomatically the maximum spin speed provided for thatpr

If you cannot open the door but you need to open it, youhave to switch the machine off by turning the selector dialto . After a few minutes the door

Cleaning the drawer recessHaving removed the draw-er, use a small brush toclean the recess, ensuringthat all washing powderresidue is removed fromthe

• Turn off the water tap.• Unscrew the hose fromthe tap.• Clean the filter in thehose with a stiff brush.• Screw the hose back onto the tap. Make sure

• : door open.Once the problem has been eliminated, press the button 7to restart the programme. If after all checks, the problempersists, contact your

Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent (creates too much foam) has beenused.• Reduce th

Problem Possible cause/SolutionSpinning starts late or the machinedoes not spin:The electronic unbalance detection device has cut in because the laund

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4Control panel _ _ _ _ _ _ _ _

Consumption valuesProgramme1)Energy consumption (KWh)2)Water consumption (litre)2)White Cottons 90 °C 2.2 72Cottons 60 °C 1.35 67Cottons 40 °C 0.85 67

PositioningInstall the machine on a flat hard floor. Make sure that aircirculation around the machine is not impeded by carpets,rugs etc. Check that t

In a sink drain pipe branch. This branch must be abovethe trap so that the bend is at least 60 cm above theground.Directly into a drain pipe at a heig

Caution! Do not remove the screw 8 !Preparation and assembly of the doorThe machine is originally prearranged for the assemblyof a door opening from r

d) Counter-magnet (6)The appliance is prearranged for a magnetic closure ofthe door.To enable a correct operation of this device, it is neces-sary to

25

26

27

www.zanussi.com/shop 132928490-A-502011

not pressing the electrical supply cable against thewall.• If the machine is situated on a carpeted floor, pleaseadjust the feet in order to allow air

Product description1Detergent dispenser drawer2Control panel3Door opening handle4Rating plate5Drain pump6Adjustable feet1 23456Detergent dispenser dra

1 32 4 5 6 791081Programme selector dial2SPIN reduction button3OPTIONS button4PREWASH button5EASY IRON button6EXTRA RINSE button7START/PAUSE button8DE

Child lockIndicator lightsDoor lockedProgramme selector dial, spin speed button and available optionsProgramme Selector DialIt allows you to switch th

After the programme has started, the time remaining isupdated every minute.• Delayed startThe Selected delay set by pressing the relevant buttonappear

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentHANDWASH 40°

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSOAK 30°Prewa