Zanussi ZHI 600 Instruction Manual download pdf (Page 11)

11

INSTALLING THE COOKER HOOD

Please ensure that when the appliance is

installed it is easily accessible to an

engineer in the event of a breakdown.

All installations must comply with the local

authorities requirements for the discharge of

exhaust air.

Incorrect installation may affect the safety of

this cooker hood.

Installation Requirements

Before installation check the wall to which the

cooker hood is to be fitted for electric cables,

water pipes or gas.

If it is necessary to fix the hood to a hollow

construction plaster or partition board

structure then it should be sufficiently

reinforced to be quite rigid in the area of the

cooker hood mounting brackets, and the

appropriate rawl plugs used for this type of

fixing (not supplied).

Ducting

The ducting must be fire retardant 100mm (4ins)

in diameter and the length should be no

more than:

3 metres with one 90° bend

2 metres with two 90° bends

Bends of more than 90° will reduce the

efficiency of the hood and reduce the airflow.

Clearance Height

The cooker hood is designed to be fitted over

a cooking appliance at the clearance heights

stated, providing the maximum output of the

appliance beneath does not exceed the

maximums quoted in the Technical Specifications.

If the output of the appliance below the cooker

hood exceeds the maximum outputs quoted,

please refer to the cooker manufacturer’s

installation instructions.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments