Zanussi ZD311R1 User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
17
Installation
Positioning
Place the refrigerator away from direct sunlight
and heat sources.
Maintain recommended ventilation - see Fig. 1.
Make sure the refrigerator is accurately levelled
turning the adjustable feet in order to avoid vibra-
tions and noises, Fig. 2.
This is a built in design to be aligned with other fur-
niture
The climate classification can be found on the
serial plate, which is located at the left on the insi-
de of the appliance.
The following table shows which ambient tempera-
ture is correct for each climate classification:
Climate classification for an ambient temperature of
SN + 10 to + 32°C
N + 16 to + 32°C
ST + 18 to + 38°C
T + 18 to + 43°C
Cleaning the interior
Do not use alcohol or any cleanig product contai-
ning alcohol because it can damage the cabinet.
Before using the appliance for the first time wash
the interior whith luke warm water and some neu-
tral soap so as to remove the typical smell of a
brand-new product arid then dry thoroughly.
Do not use detergents or abrasive powders as
these will damage the finish.
Remove security used for transportation.
Electrical connection
Before plugging the appliance make sure that the
voltage and frequency shown on the «Technical
Features» correspond to your home supply.
It is essential that the appliance be efficiently
earthed.
For this purpose the supply cable plug incorpora-
tes a special earth contact. If the sockets of your
domestic wiring system are not grounded, have
the appliance connected to a separate ground wire
in accordance with existing safety regulations.
«THE MANUFACTURER DECLINES TO ACCEPT
ANY LIABILITY IF THIS SAFETY RULE IS NOT
OBSERVED».
Starting  up
Plug the appliance into the mains.
Make sure the inner light turns on when opening
the door.
Turn to intermediate position the knob of the «tem-
perature regulator» «A».
Fig. 2
Fig. 1
Page view 2
1 2 3 4 5 6 7 8 ... 13 14

Comments to this Manuals

No comments