Zanussi ZDF18001XA User Manual

GETTING STARTED?EASY.User ManualZDF18001XAEN User ManualDishwasher

DAILY USE1. Open the water tap.2. Set the correct programme for the type of loadand the degree of soil.Make sure that the appliance is in Programmesel

The programme starts. The programme duration starts to decrease with steps of 1 minute.OPTION DELAYmax.1. Press Delay until the display shows the del

AT THE END OF THE PROGRAMME 5 min Press the on/off button to deactivate the appliance. If you don't press the on/off button, the Auto Offfunction

the tableware, we recommend that you use thetablets with long programmes.• Do not use more than the correct quantity ofdetergent. Refer to the instruc

C• Make sure that there are no residues of food or soil in or around the edge of the sump.• Put back in place the flat filter (C). Make sure that it i

Problem and alarm code Possible solutionThe appliance does not fill withwater.The display shows .• Make sure that the water tap is open.• Make sure t

Water supplyCold water or hot water 2) max 60 °CCapacity Place settings 12Power consumption Left-on mode (W) 0.99Power consumption Off-mode (W) 0.101)

17

18

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible if a

WWW.ZANUSSI.COM/SHOP156975151-A-272014

capabilities or lack of experience and knowledge if they havebeen given supervision or instruction concerning use of theappliance in a safe way and un

DISPOSALWARNING! Risk of injury orsuffocation.• Disconnect the appliance from the mainssupply.• Cut off the mains cable and discard it.• Remove the do

EASY START213451On/off button2Display3Indicators4Delay button5Programme buttonsINDICATORSMulti Tab indicator.Salt indicator. It is always off while th

ProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Duration(min)Energy(kWh)Water(l)3)AllCrockery,cutlery, potsand pans• Prewash• W

If the control panel does not show this condition, do the Reset.The Auto Off functionThis function decreases energy consumption by deactivating automa

Adjusting the water softener1. Make sure that the appliance is in Programme selection mode.2. Press and hold at the same time and until the progra

3. Press . and go off. continues to flash. The display shows thecurrent setting of the rinse aid dispenser.• = rinse aid dispenser deactivated