Zanussi ZRG616CW User Manual download pdf (Page 41)

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:

Break the circuit of the appliance.

Unscrew the plate screw fixing the lamp cover, then take

the lamp cover off in the direction of arrow and the bulb

can be changed. (Type of the bulb: Mignon 322, 230 V,

15 W, E 14 thread)

After changing bulb replace the lamp cover, screw the

plate screw and apply voltage to the appliance.

The lack of light does not influence operation of the refrig-

erator.

Problem

The appliance does not

cool sufficiently

The appliance cools too

hard

The appliance does not

cool at all

The appliance is noisy

Possible cause

Thermostatic control is set too low.

Too many foods to be cooled were put in.

Very warm foods were put in.

Door is not shut properly.

There is no inside cool air circulation.

The thermostatic control is set too high.

Plug is not connected to the mains socket properly.

There is no voltage in the mains socket.

Thermostatic control is in "0" position.

The appliance is not supported properly.

Solution

Set higher position.

Put fewer foods to be cooled.

Put foods max. at room temperature.

Check if the door is shut.

Provide inside cool air circulation.

Set lower position.

Check if the connection is proper.

Check if there is voltage.

Check setting of thermostatic control.

Check if the appliance stands stable (all the four

feet should be on the floor).

Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

If something does not work

During operation of the appliance some smaller but

annoying trouble can often occur, which does not

require calling a technician out. In the following

chart information is given about them to avoid

unnecessary charges on service.

We draw your attention that operation of appliance

goes with certain sounds (compressor- and circulat-

ing sound). This is not trouble, but means normal

operation.

We draw it to your attention again that the

appliance operates discontinuously, so the

stopping of compressor does not mean being no-

current. That is why you must not touch the electri-

cal parts of the appliance before breaking the cir-

cuit.

Instructions for the Installer

Technical data

Model

Gross capacity (l)

Net capacity (l)

Width (mm)

Height (mm)

Depth (mm)

Energy consumption (kWh/24h)

(kWh/year)

Energy class, according to EU standards

Rated current (A)

Weight (kg)

ZRG 616 CW

Fresh food comp.: 155

Fresh food comp.: 152

550

850

612

0,422

154

0,5

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Zanussi ZRG616CW User Manual Page 41

Comments to this Manuals

Related products and manuals for Fridges Zanussi ZRG616CW