Zanussi ZCV560MX User Manual download pdf (Page 7)

Before first use

Warning! Refer to the Safety chapters.

Caution! To open the oven door, always

hold the handle in the centre.

Initial Cleaning

• Remove all parts from the appliance.

• Clean the appliance before first use.

Caution! Do not use abrasive cleaning

agents! This can damage the surface.

Refer to chapter "Care and Cleaning".

Preheating

Preheat the empty appliance to burn off the re-

maining grease.

1.

Set the function

and the maximum tem-

perature.

2. Let the appliance operate for 45 minutes.

3.

Set the function

. The maximum temper-

ature for this function is 210 °C.

4. Let the appliance operate for 15 minutes.

Accessories can become hotter than usually.

The appliance can emit an odour and smoke.

This is normal. Make sure that the airflow is suf-

ficient.

Hob - Daily use

Warning! Refer to the Safety chapters.

Heat settings

Control knob Function

Off position

1 - 9

Heat settings

(1 - lowest heat setting, 9 -

highest heat setting)

1. Turn the control knob to a necessary heat

setting. The hob control indicator comes

on.

2. To complete the cooking process, turn the

control knob to the

position. If all cook-

ing zones are deactivated, the hob control

indicator goes out.

Use the residual heat to decrease energy

consumption. Deactivate the cooking zone

approximately 5 - 10 minutes before the cook-

ing is completed.

Residual heat indicator

The residual heat indicator comes on when a

cooking zone is hot.

Warning! Risk of burns from residual

heat!

Hob - Helpful hints and tips

Cookware

• The bottom of the cookware must be as

thick and flat as possible.

• Cookware made of enamelled steel and

with aluminium or copper bottoms can

cause discoloration on glass ceramic

surface.

Energy saving

• If possible, always put the lids on the

cookware.

• Put cookware on a cooking zone before

you start it.

• Stop the cooking zones before the end

of the cooking time to use residual heat.

• The bottom of pans and cooking zones

must have the same dimension.

7

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Comments to this Manuals

No comments