Zanussi ZGG62417XA User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
A. Burner cap
B. Burner crown
C. Thermocouple
Ignition of the burner
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
1. Put the flame near the burner.
2. Push the control knob down and turn it
counterclockwise to the maximum gas
supply position (
).
3. Keep the control knob pushed for equal or
less than 10 seconds. This lets the
thermocouple warm up. If not, the gas
supply is interrupted.
4. Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and its
cap are in correct positions.
WARNING!
Do not keep the control knob
pushed for more than 15 seconds. If
the burner does not light after 15
seconds, release the control knob,
turn it into off position and try to light
the burner again after minimum 1
minute.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
Turning the burner off
To put the flame out, turn the knob to the off
position .
WARNING!
Always turn the flame down or
switch it off before you remove the
pans from the burner.
Hints and tips
WARNING!
Refer to Safety chapters.
Cookware
CAUTION!
Do not use cast iron pans,
potstones, earthenware, grill or
toaster plates. The stainless steel
can become tarnished if it is too
much heated.
WARNING!
Do not put the same pan on two
burners.
WARNING!
Do not put unstable or damaged
pots on the burner to prevent from
spill and injury.
CAUTION!
Make sure that the bottoms of pots
do not stand above the control knob,
otherwise the flame heats the
control knob up.
CAUTION!
Make sure that pot handles are not
above the front edge of the cooktop.
CAUTION!
Make sure that the pots are placed
centrally on the burner in order to
get maximum stability and to get
lower gas consumption.
Diameters of cookware
Use cookware with diameters
applicable to the size of burners.
www.zanussi.com 7
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments