Zanussi ZGO63414BA User Manual download pdf (Page 7)

Burner overview

A

B

C

A. Burner cap and crown

B. Thermocouple

C. Ignition candle

Ignition of the burner

Always light the burner before you

put on the cookware.

WARNING!

Be very careful when you use open

fire in the kitchen environment. The

manufacturer declines any

responsibility in case of the flame

misuse.

1. Push the control knob down and turn it

counterclockwise to the maximum gas

supply position ( ).

2. Keep the control knob pushed for equal or

less than 10 seconds. This lets the

thermocouple warm up. If not, the gas

supply is interrupted.

3. Adjust the flame after it is regular.

If after some tries the burner does

not light, check if the crown and its

cap are in correct positions.

WARNING!

Do not keep the control knob

pushed for more than 15 seconds. If

the burner does not light after 15

seconds, release the control knob,

turn it into off position and try to light

the burner again after minimum 1

minute.

CAUTION!

In the absence of electricity you can

ignite the burner without electrical

device; in this case approach the

burner with a flame, turn the control

knob counter-clockwise to maximum

gas supply position and push it

down. Keep the control knob

pushed for equal or less than 10

seconds to let the thermocouple

warm up.

If the burner accidentally goes out,

turn the control knob to the off

position and try to light the burner

again after minimum 1 minute.

The spark generator can start

automatically when you switch on

the mains, after installation or a

power cut. It is normal.

Turning the burner off

To put the flame out, turn the knob to the off

position .

WARNING!

Always turn the flame down or

switch it off before you remove the

pans from the burner.

Hints and tips

WARNING!

Refer to Safety chapters.

Cookware

CAUTION!

Do not use cast iron pans,

potstones, earthenware, grill or

toaster plates.

www.zanussi.com 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Comments to this Manuals

No comments