Zanussi ZGO63414BA User Manual download pdf (Page 11)

DAILY USE

WARNING! Refer to Safety chapters.

BURNER OVERVIEW

A

B

C

A. Burner cap and crown

B. Thermocouple

C. Ignition candle

IGNITION OF THE BURNER

Always light the burner before you put

on the cookware.

WARNING! Be very careful when you

use open fire in the kitchen

environment. The manufacturer

declines any responsibility in case of

the flame misuse.

1. Push the control knob down and turn it

counterclockwise to the maximum gas supply

position ( ).

2. Keep the control knob pushed for equal or less

than 10 seconds. This lets the thermocouple

warm up. If not, the gas supply is interrupted.

3. Adjust the flame after it is regular.

If after some tries the burner does not

light, check if the crown and its cap

are in correct positions.

WARNING! Do not keep the control

knob pushed for more than 15

seconds. If the burner does not light

after 15 seconds, release the control

knob, turn it into off position and try to

light the burner again after minimum 1

minute.

CAUTION! In the absence of

electricity you can ignite the burner

without electrical device; in this case

approach the burner with a flame, turn

the control knob counter-clockwise to

maximum gas supply position and

push it down. Keep the control knob

pushed for equal or less than 10

seconds to let the thermocouple warm

up.

If the burner accidentally goes out,

turn the control knob to the off position

and try to light the burner again after

minimum 1 minute.

The spark generator can start

automatically when you switch on the

mains, after installation or a power cut.

It is normal.

The hob is supplied with the

progressive valves. They make the

flame regulation more precise.

TURNING THE BURNER OFF

To put the flame out, turn the knob to the off

position .

WARNING! Always turn the flame

down or switch it off before you

remove the pans from the burner.

11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments