Zanussi ZCG550GWC User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
To bake and roast or as pan to collect fat.
The roasting pan grid
To put in the deep roasting pan.
Before first use
Warning! Refer to the Safety chapters.
Initial Cleaning
Remove all accessories and removable shelf
supports (if applicable).
Clean the appliance before first use.
Important! Refer to the chapter "Care and
cleaning".
Setting the time
You must set the time before you operate
the oven.
When you connect the appliance to the elec-
trical supply or after a power cut, the indicator
for the Time of Day function flashes.
Press the + or - button to set the correct time.
After approximately five seconds, the flashing
stops and the display shows the time of day
you set.
To change the time, press
again and
again until the indicator for the Time of
Day function flashes.
Preheating
Set an oven to maximum temperature and run
an empty oven for 45 minutes, to burn off any
residue from the cavity surface. Accessories
can become hotter than in normal use. During
this period an odour can be emitted. This is
normal. Make sure the room is well ventilated.
Hob - Daily use
Warning! Refer to the Safety chapters.
Lighting the burners
Warning! Be very careful when you use
open fire in a kitchen environment. The
manufacturer declines all responsibility in case
of misuse of the flame.
Always light the burner before you put
cookware on it.
1.
Turn the knob to the maximum position
and push it down. When you push the
knob, the spark generator activates auto-
matically.
2. Keep the control knob pushed for approxi-
mately 5 seconds. This lets the thermo-
couple warm up. If not, the gas supply is
interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are in
the correct positions.
8
7
6
9
3
4
5
2
1
1
Burner cap
2
Burner crown
3
Ignition candle
4
Thermocouple
5
Hob
6
Slots
7
Burner body
8
Location peg
9
Hole
8
www.zanussi.com
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments