Zanussi ZCG550GWC User Manual download pdf (Page 9)

Replacing burner parts

1. Carefully put the burner crown on the

burner body. Do not use force.

a) Make sure that the hole in the crown

is above the ignition candle.

b) Make sure that the location pegs are

in the slots in the burner body.

c) Let the crown fall freely onto the

body.

d) Make sure that you can move the

crown a small distance from side to

side.

2. Put the burner cap centrally on top of the

crown (enamel side up). Move the cap

from side to side and front to back to

make sure that it is correctly installed.

3. Try to light the burner. If the burner does

not ignite, adjust the crown and cap again.

Warning! Do not keep the control knob

pushed for more than 15 seconds.

If the burner does not light after 15 seconds,

release the control knob, turn it into off

position and try to light the burner again after

minimum 1 minute.

If the burner accidentally goes out, turn

the control knob to the off position and try

to light the burner again after minimum 1 mi-

nute.

The spark generator can start automati-

cally when you switch on the mains, after

installation or a power cut. It is normal.

Turning the burner off

To put the flame out, turn the knob to the sym-

bol

.

Warning! Always turn the flame down or

switch it off before you remove the pans

from the burner.

Hob - Helpful hints and tips

Warning! Refer to the Safety chapters.

Energy savings

• If possible, always put the lids on the pans.

• When the liquid starts to boil, turn down the

flame to barely simmer the liquid.

Use pots and pans with diameter applica-

ble to the dimension of burner.

Burner Diameters of cookware

Rapid 180 mm - 260 mm

Semi-rapid 120 mm - 220 mm

Auxiliary 80 mm - 160 mm

Use cookware with the bottom as thick and

flat as possible.

Hob - Care and cleaning

Warning! Refer to the Safety chapters.

Warning! Switch the appliance off and

let it cool down before you clean it.

Warning! For safety reasons, do not

clean the appliance with steam cleaners

or high-pressure cleaners.

Warning! Do not use abrasive cleaners,

steel wool pads or acids, they can cause

damage to the appliance.

• To clean the enamelled parts, cap and

crown, wash it with warm soapy water.

• Stainless steel parts wash with water, and

then dry with a soft cloth.

•The pan supports are not dishwasher

proof; they must be washed by hand.

• Make sure you position the pan supports

correctly after cleaning.

• To make burners work correctly, make sure

that the arms of the pan supports are in the

centre of the burner.

• Be very careful when you replace the

pan supports to prevent the hob top

from damage.

9

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments