Zanussi ZCM 700 X User Manual download pdf (Page 30)

Commissioning

When the hob has been fully installed it will be

necessary to check the minimum flame setting. To do

this, follow the procedure below.

- Turn the gas tap to the MAX position and ignite.

- Set the gas tap to the MIN flame position then turn

the control knob from MIN to MAX several times.

If the flame is unstable or is extinguished follow

the procedure below.

Procedure:

Re-ignite the burner and set to MIN.

Remove the control knob.

The adjustment screw is located below the

gas tap control shaft (see diagram).

To adjust, use a thin bladed screwdriver and

turn the adjustment screw until the flame is

steady and does not extinguish, when the

knob is turned from MIN to MAX. Repeat

this procedure for all burners.

Pressure Testing

Remove left hand pan support and front left

burner cap and crown.

Fit manometer tube over the injector.

Turn on the burner gas supply and ignite

another burner supply.

The pressure reading should be nominally

20mbar and must be between 17 mbar and

25mbar.

Turn off the burner supplies.

FO 2412

☞

1 2 ... 25 26 27 28 29 30 31 32

No comments

Zanussi ZCM 700 X User Manual Page 30