Zanussi ZDH8333W User Manual download pdf (Page 14)

TROUBLESHOOTING

Problem Possible solution

You cannot activate the appliance. Make sure that the mains plug is connected to

the mains socket.

Check fuse in fuse box (domestic installation).

The programme does not start. Press Start/Pause.

Make sure that the appliance door is closed.

The appliance door does not close. Make sure that the installation of the filter is cor-

rect.

Make sure that the laundry does not catch be-

tween the appliance door and the rubber seal.

The appliance stops during operation. Make sure that the water container is empty.

Press Start/Pause to start the programme again.

The display shows a long programme duration.

1) Make sure that the weight of the laundry is appli-

cable to the duration of the programme.

Make sure that the filter is clean.

The laundry is too wet. Spin the laundry in the

washing machine again.

Make sure that the room temperature is not too

warm.

The display shows a short programme duration. Set the Time Drying or the Extra Dry programme.

The display shows Err. If you want to set a new programme, deactivate

and activate the appliance.

Make sure that the options are applicable to the

programme.

The display shows (e.g. E51). Deactivate and activate the appliance. Start a

new programme. If the problem occurs again,

contact the Service.

1) After maximum 5 hours, the programme ends automatically

If the drying results are not satisfactory

• The set programme was incorrect.

• The filter is clogged.

• The condenser is clogged.

• There was too much laundry in the appliance.

• The drum is dirty.

• Incorrect setting of the conductivity sensor.

• The airflow slots are clogged.

TECHNICAL DATA

Height x Width x Depth 850 x 600 x 600 mm (maximal 680 mm)

Max. depth with the appliance door open 1090 mm

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Zanussi ZDH8333W User Manual Page 14