Zanussi ZTA250 User Manual download pdf (Page 11)

Important! The hot air emitted by the tumble dryer can

reach temperatures of up to 60°C. The appliance must

therefore not be installed on floors which are not

resistant to high temperatures.

When operating the tumble dryer, the room

temperature must not be lower than +5°C and higher

than +35°C, as it may affect the performance of the

appliance.

Warning! Should the appliance be moved, it

must be transported vertically.

Warning! The appliance must not be installed

behind the lockable door, a sliding door or a door

with a hinge on the opposite side to that of the

appliance.

Removing transport safety packaging

Caution! Before use all parts of the transport

packaging must be removed.

1. Open loading door.

2. Pull off adhesive strips

from inside machine on

top of drum.

3. Remove foil hose and

polystyrene padding

from the machine.

Fitting the vent hose

To simplify the installation, there is a choice of vent

outlets: one at the back, the others in the left and right-

hand side. Connect the hose to whichever is the more

convenient by pulling the ring nut (A) from the vent out-

let at the back, screwing it on to the hose and pushing

it firmly back into place. The unused vents should now

be sealed with the special snap covers provided.

Once connected to the dry-

er, run the vent hose to the

desired outlet point, ensur-

ing that the run’s overall

length is less than 2 m, and

that it contains no more

than two bends. As to the

outlet itself, if you have decided on a fixed wall/window

grille, a good local builder’s merchant should be able

to supply you with the necessary fittings and installation

advice.

Warning!

It is important not to

connect the vent hose to,

for example, a cooker

hood, or a chimney or flue

pipe designed to carry the

exhaust from a fuel burning

appliance.

Note that to avoid conden-

sation problems, it is essential that the dryer be fitted

with the flexible hose to carry its “exhaust” at least be-

yond the kitchen units; preferable outside the kitchen.

In order to prevent the appliance from overheating, it is

important that the steam exhaust is unobstructed.

Therefore, in case of a permanent hose fitted to an

exterior wall or ceiling, it must be ensured an exhaust

capacity of at least 150 m3/h. If the dryer is fitted next

to kitchen units, make sure that the vent hose is not

squashed. If the hose is partially squashed, drying ef-

ficiency will be reduced, resulting in longer drying times

and higher energy consumption. If the hose is com-

pletely squashed, the safety cut-outs with which the

machine is fitted may operate. When operating the

tumble dryer, the room temperature must not be lower

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Zanussi ZTA250 User Manual Page 11

Comments to this Manuals

Related products and manuals for Tumble dryers Zanussi ZTA250