Zanussi FCS1020C User Manual download pdf (Page 14)

• Unscrew the inlet hose from the supply tap.

• Select a wash programme, start the machine

and let the programme run for a short time.

• Interrupt the programme by turning the pro-

gramme selector to

position.

• Place the end of inlet and drain hoses down

low, into the waste gully (floor drain) set into

the floor. Make sure that the end of the hose

does not go below the water level in the gul-

ly's (drain's) water tap.

• Select the programme "Drain" and let it run

until it is finished.

•

Turn the programme selector to

position.

When you intend to start the machine up

again, make sure that the room temperature

is above 0 °C.

The appliance is only to be used and stored in-

doors at normal room temperature. The manu-

facturer is not responsible for any frost damage.

What to do if…

Certain problems are due to lack of simple

maintenance or oversights, which can be

solved easily without calling out an engineer.

Before contacting your local Service Centre,

please carry out the checks listed below.

During machine operation it is possible that the

End pilot light blinks to indicate that the ma-

chine is not working:

• 1 flash: problem with the water supply.

• 2 flashes: problem with the water draining.

• 4 flashes: door open.

Once the problem has been eliminated, press

the button START to restart the programme. If

after all checks, the problem persists, contact

your local Service Centre.

Problem Possible cause/Solution

The machine does not start:

The door has not been closed.

• Close the door firmly.

The plug is not properly inserted in the power socket.

• Insert the plug into the power socket.

There is no power at the socket.

• Please check your domestic electrical installation.

The main fuse has blown.

• Replace the fuse.

The selector dial is not correctly positioned and the button Start has not

been pressed.

• Please turn the selector dial and press the button Start again.

The machine does not fill:

The water tap is closed.

• Open the water tap.

The inlet hose is squashed or kinked.

• Check the inlet hose connection.

The filter in the inlet hose is blocked.

• Clean the water inlet hose filter.

The door is not properly closed.

• Close the door firmly.

The machine fills then emp-

ties immediately:

The end of the drain hose is too low.

• Refer to relevant paragraph in «Installation» chapter.

www.zanussi.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments

Zanussi FCS1020C User Manual Page 14

Comments to this Manuals

Related products and manuals for Washing machines Zanussi FCS1020C