Zanussi FCS1020C User Manual download pdf (Page 19)

Connect the hose to

a tap with a 3/4”

thread. Always use

the hose supplied

with the appliance.

The machine end of

the inlet hose can be

turned in any direc-

tion. Set the hose

correctly by loosening

the ring nut. After po-

sitioning the inlet

hose, be sure to

tighten the ring nut

again to prevent

leaks.

The inlet hose must not be lengthened. If it is

too short and you do not wish to move the tap,

you will have to purchase a new, longer hose

specially designed for this type of use.

Water drainage

The end of the drain hose can be positioned in

three ways:

Hooked over the edge of a sink using

the plastic hose guide supplied with the

machine.

In this case, make sure the end cannot come

unhooked when the machine is emptying. This

could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe with a trap.

650-800 mm

The drain hose can be connected directly into

the pipe (e.g. beneath a washtub or sink),

above the water trap. The drain hose must be

arranged so that some part of it’s length is rout-

ed up to a level corresponding to the top edge

of the tub and fixed in place there.

Directly into a drain pipe at a height of not

less than 65 cm and not more than 80 cm.

Their must be an air gap around and below the

end of drain hose. This means that the internal

diameter of the standpipe must be larger than

the outer diameter of the hose.

650-800 mm

40 mm

The hose must not be sticked into the stand-

pipe more than 50 mm and it has to be fixed in

this position. The drain hose must not be

kinked.

The drain hose can be extended up to total 3,5

m. For the extension piece use a hose with an

internal diameter at least as large as that of the

machine's own hose. Use a suitable hose con-

nector.

19

www.zanussi.com

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments