Zanussi ZWD1261 User Manual download pdf (Page 14)

Interrupting a programme

Press the button 7 to interrupt a programme which is

running, the corresponding pilot light starts blinking.

Press the button again to restart the programme.

Cancelling a programme

Turn the selector dial to to cancel a programme which

is running. Now you can select a new programme.

Opening the door after the programme has started

First set the machine to pause by pressing the button 7 .

If the pilot light 9 goes off, the door can be opened.

If the pilot light 9 remains lit, this means that the machine

is already heating or that the water level is too high. In

any case, do not force the door!

If you cannot open the door but you need to open it, switch

the machine off by turning the selector dial to

. After

a few minutes the door can be opened.

(Pay attention to the water level and temperature!).

After closing the door, it is necessary to select the pro-

gramme and options again and to press button 7 .

At the end of the programme

The machine stops automatically. The blinking appears

on the display, the pilot light of button 7 and the pilot light

9 go off.

If a programme or an option that ends with water left in

the tub has been selected, the pilot light 9 remains on and

the door is locked to indicate that the water must be emp-

tied out before opening the door.

Follow the below instructions to empty out the water:

Turn the programme selector dial to

2. Select the draining or spinning programme.

3. Reduce the spin speed if needed, by pressing the

relevant button.

4. Press button 7 .

At the end of the programme, the door is released and can

be opened. Turn the programme selector dial to

switch the machine off.

Remove the laundry from the drum and carefully check

that the drum is empty. If you do not intend to carry out

another wash, close the water tap. Leave the door open to

prevent the formation of mildew and unpleasant smells.

Stand by : once the programme has finished after a few

minutes the energy saving system will be enabled. The

brightness of the display is reduced. By pressing any

button the appliance will come out of the energy saving

status.

Use - Drying

Drying only

The recommended load size is 4 kg for cottons and linen,

and 3 kg for synthetic items.

Note! By pressing Drying Time button it is also possible

to dry up to 6 kg of cotton items (see the «Drying Pro-

gramme» table).

The water tap must be open and the drain hose must be

positioned in the sink or connected to the drain pipe.

1. Load the laundry.

2. Select a spin cycle at the maximum spin speed al-

lowed for the type of laundry in order to obtain the

best drying performances.

3. Select the drying programme for Cottons or Synthetic

in the Drying sector of the programme selector dial.

4. If you wish to select an electronic drying, press the

button 3 until the pilot light corresponding to the re-

quired dryness degree illuminates.

5. If you wish to select a timed drying, press button 4

until the time you want appears on the display (see

the «Drying Programmes» table). Every time you

press this button the drying time increases by 5 mi-

nutes.

Note!

The programme time will automatically increase by a

few minutes.

6. Press button 7 to start the programme.

After the programme has started, the time remaining

is updated every minute.

Note!

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments

Zanussi ZWD1261 User Manual Page 14

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWD1261