Zanussi ZWF1022 User Manual

ENUser manualWashing MachineZWF 1022

Daily useSort out the laundryFollow the wash code symbols on each garment label andthe manufacturer’s washing instructions. Sort the laundryas follows

Close the door gentlyWarning! Make surethat any fabrics werenot trapped when closingthe door.Detergents and additivesGood washing results also depend

• Remove the drawer. Push the drawer edge outwardswhere indicated by the arrow (PUSH) to facilitatedrawer removal.The flap is down and you wish to use

90°60°40°30°3H6H9HAUTO+1 2 3 4 657.17.27.31Programme selector dialTurn the programme selector dial to the required programme. The selectordial can be

3Automatic Spin reduction andRinse HoldAUTOBy selecting a programme, the appliance proposes automatically the max-imum spin speed provided for that pr

5Delay Start3H6H9HThe start of the programme can be delayed by 9, 6 or 3 hours by means ofthis button. The relevant light illuminates.You must select

7.17.27.3Indicator pilot lights• When you start the programme by pressing the button 6 , the washingphase pilot light ( 7.1 ) illuminates. This means

Programme - Maximum and Minimum Temperature - Cycle De-scription - Maximum Spin Speed - Maximum Fabrics Load - Typeof LaundryOptionsDetergent Com-part

Programme - Maximum and Minimum Temperature - Cycle De-scription - Maximum Spin Speed - Maximum Fabrics Load - Typeof LaundryOptionsDetergent Com-part

Programme - Maximum and Minimum Temperature - Cycle De-scription - Maximum Spin Speed - Maximum Fabrics Load - Typeof LaundryOptionsDetergent Com-part

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4Environment concerns _ _ _ _ _ _ _ _

• The drum should be empty of laundry.• Select the hottest cotton wash programme.• Use a normal measure of detergent, must be a powderwith biological

• remove the filter and clean it under the tap;• if necessary, place thefilter cover in the rightposition again.• open the filter coverand insert the

What to do if…The appliance does not start or stops during operation.Certain problems are due to lack of simple maintenanceor oversights, which can be

Fault code and malfunction Possible cause / SolutionThe light of button 6 flashesand the light 7.3 illuminates:Door openThe door has not been closed o

Malfunction Possible cause / SolutionThe door will not open:The programme is still running.• Wait the end of washing cycle.The door lock has not been

The necessary data for the service centre is on the ratingplate. We recommend that you write the data here:Mod. ... ... ...Prod. No. ... ... ...

26

27

www.zanussi.com/shop 132 943 210 - 00 - 192010

• Install the appliance on a flat hard floor.• Never place cardboard, wood or similar materials un-der the appliance to compensate for any unevennessi

To activate this device, ro-tate the button (withoutpressing it) inside thedoor clockwise until thegroove is horizontal. Ifnecessary use a coin.To dis

Ecological hintsTo save water, energy and to help protect the environment,we recommend that you follow these tips:• Normally soiled laundry may be was

Water supply pressure MinimumMaximum0,05 MPa0,8 MPaMaximum Load Cotton 6 kgSpin Speed Maximum 1000 rpmInstallationUnpackingWarning!• Read carefully th

• Remove the power supply cable and the draining andinlet hose from the hose holders ( C ) on the rear ofthe appliance.• Unscrew the three bolts ( A )

Accurate levelling prevents vibration, noise and dis-placement of the appliance during operation.Repeat the levelling action, if the appliance is not

The drain hose may be extended to a maximum of4 metres. An additional drain hose and joining pieceis available from your Local Centre.Connections over