Zanussi ZWH 6145 User Manual download pdf (Page 15)

15

Operating sequence

1. Load the laundry

Open the door by

carefully pulling the

door handle outwards.

Place the laundry in

the drum, one item at

a time, shaking them

out as much as

possible. Close the door.

2.Measure out the detergent and the fabric

softener

Pull out the dispenser drawer until it stops.

Measure out the amount of detergent required,

pour it into the main wash compartment

and, if you wish to carry out a programme with

the prewash phase or the soak programme,

pour it into the compartment marked .

If required, pour fabric softener into the

compartment marked (the amount used

must not exceed the «MAX» mark in the

drawer). Close the drawer gently.

Select the required programme by means of

the programme selector dial

(1)

Turn the programme selector dial to the

required programme.

The green light of button 8 starts to flash.

It can be turned either clockwise or

anticlockwise.

On position «O» the programme is reset and

the machine is switched OFF.

At the end of the programme the selector

dial must be turned to position «O», to

switch the machine off.

ATTENTION!

If you turn the programme selector dial to ano-

ther programme when the machine is working,

tthe red pilot light of button

8 will flash 3 times

and the message Err is displayed on the dis-

play to indicate a wrong selection. The machi-

ne will not perform the new selected program-

me.

Select the spin speed, the Rinse Hold

option by pressing button

2

When selecting a programme, the light

corresponding to the maximum speed allowed

for that programme will illuminate. The

relevant light will light up.

Select the desired option by means of

buttons

3,

4, 5 and 6

Depending on the programme, different

functions can be combined. These must be

selected after choosing the desired programme

and before depressing the button 8.

For the compatibility of the options with the

washing programmes, refer to the section

«Programmes table».

Start the programme by pressing button

8

To start the selected programme, press this

button; the corresponding green pilot light

stops flashing.

On programme progress display the pilot light

DOOR illuminates to indicate that the appliance

starts operating and the door is locked.

IMPORTANT!

If an option which is not compatible with the set

wash programme is selected, the message Err

is displayed for few seconds and the red light

of this button flashes for 3 times.

192997920_GB.qxd 14/12/2007 17.09 Pagina 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Comments to this Manuals

No comments