Zanussi ZWH 6145 User Manual download pdf (Page 17)

17

Altering an option or a running programme

It is possible to change any option before the

programme carries it out.

Before you make any change, you must pause

the washing machine by pressing button

8.

Changing a running programme is possible

only by resetting it. Turn the programme

selector dial to «O» and then to the new

programme position. Start the new programme

by depressing button

8 again.

The washing water in the tub will not empty

out.

Interrupting a programme

Depress tbutton

8 to interrupt a programme

which is running, the corresponding light starts

to flash. Depress the button again to restart the

programme.

Cancelling a programme

Turn the selector dial to «O» to cancel a

programme which is running. Now you can

select a new programme.

Opening the door after the programme has

started

First set the machine to pause by pressing the

button

8.

If the light DOOR goes off, after some minutes,

the door can be opened. If it does not switch

off, this means that the machine is already

heating, that the water level is above the

bottom edge of the door. In this cases the door

cannot be opened.

If you cannot open the door but you need to

open it you have to switch the machine off by

turning the selector dial to «O». After few

minutes the door can be opened

(Pay attention to the water level and

temperature!).

After this procedure, it will be necessary to set

the programme and the options again and then

to depress button 8.

At the end of the programme

The machine stops automatically. Some

acustic signals sound and on the display will

appear a flashing «

0 ». The button 8 light and

the light DOOR go off. The door can be

opened.

If at the end of a programme there is water in

the tub, to empty out the water follow the

following instructions:

1.turn the programme selector dial to «O»

2.select the DRAIN or SPIN programme

3.reduce the spin speed, if needed, by means

of the button

2

4.depress button 8

5.at the end of programme, the display shows

a flashing zero «0», the light DOOR goes off

and it will be possible to open the door.

At the end of the cycle, turn the programme

selector dial to «O» to switch the machine off.

Remove the laundry from the drum and

carefully check that the drum is empty.

If you do not intend to carry out another wash,

close the water tap.

Leave the door open to prevent the formation

of mildew and unpleasant smells.

192997920_GB.qxd 14/12/2007 17.09 Pagina 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Comments to this Manuals

No comments