Zanussi ZWI71000WA User Manual download pdf (Page 23)

• a) Door

The dimensions of the door should be:

- width 595-598 mm

- thickness 16-22 mm

The height (C-Fig. C) depends on the height

of the adjacent furniture's base.

• b) Hinges

To mount the hinges it is necessary to drill

two holes (dia. 35 mm, depth 12.5-14 mm

depending on the depth of door furniture) on

the inner side of the door. The distance be-

tween the holes hobs fixing centres must be

416 mm.

The distance (B) from upper edge of the door

to the centre of the hole depends on the adja-

cent furniture's dimensions.

The required dimensions are given in the pic-

ture C.

The hinges will be fixed to the door by means

of screws for wood (2-Fig. B) supplied with

the appliance.

• c) Mounting the door

Fix the hinges (1) to the machine by means of

the M 5x15 screws (3-Fig. B). The hinges can

be adjusted to compensate for possible un-

even thickness of the door.

To align the door perfectly it is necessary to

loosen the screw (3-Fig. B), adjust the door

and tighten the screw again.

D

4

6

8

Caution! Do not remove the screw 8 !

d) Counter-magnet (6)

The appliance is prearranged for a magnetic

closure of the door.

To enable a correct operation of this device, it

is necessary to screw the counter-magnet (6)

(steel disk + rubber ring) into the inner side of

the door. Its position must correspond to the

magnet (4) on the appliance (see picture D).

E

1

2

3

7

5

6

4

8

Caution! Do not remove the screw 8 !

If the door has to be opened from left to right,

invert the position of the plates (7), the mag-

net (4) and the plate (5) (Fig. B and E). Mount

the counter-magnet (6) and the hinges (1) as

previously described.

23

www.zanussi.com

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments