GETTING STARTED?EASY.User ManualZDT 21002FAEN User ManualDishwasher
ADDING MULTI-TABLETS212030• Do not fill the salt container and the rinse aid dispenser.• Adjust the water softener to the lowest level.• Set the rinse
END OF THE PROGRAMME• Press the on/off button to deactivate the appliance.• Close the water tap.If you do not press the on/off button, after few minut
WHAT TO DO IF YOU WANT TO STOP USINGMULTI-TABLETSBefore you start to use separately detergent, saltand rinse aid do the following procedure.1. Set the
C• Make sure that there are no residues of food or soil in or around the edge of the sump.• Put back in place the flat filter (C). Make sure that it i
Problem and alarm code Possible cause and solutionYou cannot activate the appliance. • Make sure that the mains plug is connected to themains socket.•
Refer to "Before first use", "Dailyuse", or "Hints and tips" for otherpossible causes.Once you have checked the applianc
Problem Possible cause and solutionThere are residues of detergentin the dispenser at the end of theprogramme.• The detergent tablet got stuck in the
RATING PLATEMod. ... ... ...Prod. No. ... ... ... Ser. No. ...INFORMATION FOR TEST INSTITUTESFor all the necessary information for testperfor
18
SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible if a
WWW.ZANUSSI.COM/SHOP100006951-A-242015
• Do not keep the appliance door open without supervision toprevent to fall on it.• Before maintenance, deactivate the appliance and disconnectthe mai
DISPOSALWARNING! Risk of injury orsuffocation.• Disconnect the appliance from the mainssupply.• Cut off the mains cable and discard it.• Remove the do
EASY START453211On/off button2Programme indicators3Indicators4Programme button5Half load buttonINDICATORSRunning programme indicator. It comes on when
ProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Duration(min)Energy(kWh)Water(l)4)Fresh soilCrockery andcutlery• Wash 60 °Cor 6
Press the programme button until all programme indicators are on (Programme selection mode).With this function you can cancel the running programme.US
German degrees(°dH)French degrees(°fH)mmol/l Clarke degreesWater softenerlevel19 - 22 33 - 39 3.3 - 3.9 23 - 275 1)15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
working. The washing phase starts only after thisprocedure is completed. The procedure will berepeated periodically.ADDING SALTBefore first use put on
Comments to this Manuals