Zanussi ZQS3140A User Manual download pdf (Page 7)

Problem Possible cause Solution

The lamp is defective. Refer to "Replacing the lamp".

The compressor operates contin-

ually.

The temperature is not set correctly. Set a higher temperature.

The door is not closed correctly. Refer to "Closing the door".

The door has been opened too fre-

quently.

Do not keep the door open longer than

necessary.

The product temperature is too high. Let the product temperature decrease to

room temperature before storage.

The room temperature is too high. Decrease the room temperature.

Water flows on the rear plate of

the refrigerator.

During the automatic defrosting proc-

ess, frost defrosts on the rear plate.

This is correct.

Water flows into the refrigerator. The water outlet is clogged. Clean the water outlet.

Products prevent that water flows into

the water collector.

Make sure that products do not touch

the rear plate.

Water flows on the ground. There is too much water in the air de-

flector.

Clean the air deflector.

The temperature in the appliance

is too low.

The temperature regulator is not set

correctly.

Set a higher temperature.

The temperature in the appliance

is too high.

The temperature regulator is not set

correctly.

Set a lower temperature.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too high. Let the product temperature decrease to

room temperature before storage.

Many products are stored at the same

time.

Store less products at the same time.

There is no cold air circulation in the

appliance.

Make sure that there is cold air circula-

tion in the appliance.

Replacing the lamp

Caution! Disconnect the plug from the mains

socket.

1. Remove the screw

from the lamp

cover.

2. Remove the lamp

cover (refer to the

illustration).

3. Replace the used

lamp with a new

lamp of the same

power and specifically designed for household ap-

pliances (the maximum power is shown on the lamp

cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Zanussi ZQS3140A User Manual Page 7

Comments to this Manuals

Related products and manuals for Fridges Zanussi ZQS3140A