Zanussi ZCV552MWC User Manual download pdf (Page 19)

• Appliance left the factory fully packaged. If it

is delivered without packaging and damage

has occurred, the manufacturer cannot ac-

cept responsibility. Contact your supplier for

advice.

• Do not move the appliance by hand after re-

moved the packaging. Do not use a sack

barrow or any other aid to lift the appliance. It

can cause a damage.

• To move the appliance, open the oven door

and lift the appliance by holding inside the

top of the component.

• You can fit your freestanding appliance with

cabinets on one or both sides and in the cor-

ner.

• Protect sidewalls above the hob level by heat

resistant noncombustible material and pro-

vide minimum 40 mm distance from the side-

walls to the hob side.

• Provide minimum 2 mm air gap at either side

of the appliance to enable moving it into po-

sition.

• Surfaces above the hob (also cooker hoods)

must be a minimum of 685 mm above the

hob.

Electrical installation

Warning! Only a qualified and competent

person must do the electrical installation.

The manufacturer is not responsible if you

do not follow safety precautions from the

chapter "Safety information".

This appliance is supplied without a main plug

or a main cable.

Covering terminal board

The recommended cross-section area is six

square millimetres (6 mm²).

When you refit the mains terminal cover, make

sure that the lower tabs are located inside the

bottom edge of the aperture, before you fix the

two screws into the top edge of the mains ter-

minal cover.

Make sure that the cover is securely fastened.

To open the cover of terminal board obey

the procedure in opposite sequence.

Terminal board

Make sure that the links are fitted as shown.

NNNLL

Do not remove blanking plates.

Environment concerns

The symbol on the product or on its

packaging indicates that this product may not

be treated as household waste. Instead it

should be taken to the appropriate collection

point for the recycling of electrical and

19

www.zanussi.com

1 ... 18 19 20 21 22 23 24

Comments to this Manuals

No comments