Zanussi ZES3921IBA User Manual download pdf (Page 18)

Installation

WARNING!

Refer to Safety chapters.

Before the installation

Before you install the hob, write down the

information bellow from the rating plate. The

rating plate is on the bottom of the hob.

Model .......................................

PNC .........................................

Serial number ...........................

Built-in hobs

Only use the built-in hobs after you assemble

the hob into correct built-in units and work

surfaces that align to the standards.

Connection cable

• The hob is supplied with a connection cable.

• To replace the damaged mains cable use

the following (or higher) mains cable type:

H05V2V2-F T min 90°C. Speak to your local

Service Centre.

Installation of more than one hob

40-50 mm

55 mm

30 mm

min. 650 mm

490 mm

min. 100 mm

270 mm

If several 30 cm hobs are to be installed side by

side into the same cut out, an assembly kit

including a support side bracket and

supplementary seals is available at our

Authorised Service Centres. The relevant

installation instructions are supplied within the

kit package.

Assembly

270

+1

mm

R 5mm

min.

55mm

490

+1

mm

A

Place the sealing gasket A all around the edge

of the cut out.

Fit the hob in the cut out and push it down until

comes in contact with the kitchen top surface.

then remove the excess sealing.

18 www.zanussi.com

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comments to this Manuals

No comments