Zanussi ZES 3921 IBA User Manual download pdf (Page 20)

Electrical connection

• Ground the appliance according to safety

precautions.

• Make sure that the rated voltage and type of

power on the rating plate agree with the volt-

age and the power of the local power supply.

• This appliance is supplied with a mains ca-

ble. It has to be supplied with a correct plug,

able to support the load marked on the rating

plate. The plug has to be fitted in a correct

socket.

• Any electrical component must be installed

or replaced by the Service Force Centre

technician or qualified service personnel.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• The appliance must not be connected with

an extension cable, an adapter or a multiple

connection (risk of fire). Check that the

ground connection is in conformity with the

standard and regulations force.

• The power cable must be placed in such a

way that it does not touch any hot part.

• Connect the appliance to the mains with a

device that lets to disconnect the appliance

from the mains at all poles with a contact

opening width of minimum 3 mm, eg. auto-

matic line protecting cut-out, earth leakage

trips or fuse.

• None of a parts of the connection cable can

not get a temperature 90 °C. The blue neu-

tral cable must be connected to the terminal

block label with "N". The brown (or black)

phase cable (fitted in the terminal block con-

tact marked with "L") must always be con-

nected to the live phase.

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make sure

that the cable section is applicable to the volt-

age and the working temperature. The yellow/

green earth wire must be approximately 2 cm

longer than the brown (or black) phase wire.

Assembly

40-50 mm

55 mm

30 mm

min. 650 mm

490 mm

min. 100 mm

270 mm

If several 30 cm hobs are to be installed side by

side into the same cut out, an assembly kit in-

cluding a support side bracket and supplemen-

tary seals is available at our Service Centres.

The relevant installation instructions are sup-

plied within the kit package.

=

=

270

+1

mm

600mm

R 5mm

490

+1

mm

20

www.zanussi.com

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Comments to this Manuals

No comments