Zanussi ZKN7147J User Manual

ENUser manualWasher DryerZKN 7147 J

Timed ProgrammesDegree of Drying Type of Fabric Drying LoadSpin Speed(rpm)Suggested dry-ing time (mi-nutes)Cupboard drySuitable for items to put away

Red wine: soak in water and detergent, rinse and treat withacetic or citric acid, then rinse. Treat any residual markswith bleach.Ink: depending on th

• Also, fabrics containing residue of setting lotions orhair sprays, nail solvents or similar solutions must notbe machine dried in order to avoid the

Daily UseLoad the laundryOpen the door by carefullypulling the door handleoutwards. Place the laun-dry in the drum, one itemat a time, shaking themout

Select the Delay Start by pressing button 8Before you start the programme, if you wish to delay thestart, press this button to select the desired dela

Use - DryingDrying onlyCaution! The recommended load size is 4 kg for cottons and linenand 3 kg for synthetic items.By pressing Drying Time button it

5. Set the dryness degree by pressing button 3. Thedisplay shows the whole duration of the washing andthe set drying cycle.6. Start the programme by p

Cleaning the dispenser drawerThe washing powder and additive dispenser drawershould be cleaned regularly.Remove the drawer bypressing the catch down-w

Pull back the drainage duct.Unscrew the filter and remove it.Remove fluff and objects from the pump.Make sure that the impeller of the pump can turn.

35°45°• Screw the hose back to the machine and make surethe connection is tight.• Turn on the water tap.Frost precautionsIf the machine is installed i

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4Control panel _ _ _ _ _ _ _ _

Problem Possible cause/SolutionThe washing machine does not start:The door has not been closed. • Close the door firmly.The plug is not properly inser

Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent (creates too much foam) has beenused.• Reduce th

Problem Possible cause/SolutionSpinning starts late or the machinedoes not spin:The electronic unbalance detection device has cut in because the laund

If you are unable to identify or solve the problem, contactour service centre. Before telephoning, make a note of themodel, serial number and purchase

InstallationUnpackingAll transit bolts and packing must be removed before us-ing the appliance.You are advised to keep all transit devices so that the

Caution! Before connecting up the appliance to newpipework or to pipework that has not been used forsome time, run off a reasonable amount of water to

Min. 60 cm (23.6”)Max. 90 cm (35.4”)If your drain hose lookslike this (see beside) youdo not require the “U”piece”. Just push the hosefirmly in to the

In the event of having to change the fuse in the plug sup-plied, a 13 amp ASTA approved (BS1363/A) fuse must beused.Warning! A cut off plug inserted i

www.zanussi.com/shop 132935111-A-162011

• After having installed the appliance, check that it is notstanding on the inlet and drain hose and the worktop isnot pressing the electrical supply

Product description1 Detergent dispenser drawer2 Control panel3 Door opening handle4 Rating plate5 Drain pump6 Adjustable feet123456Detergent dispense

Control panelOn the following page there is a picture of the control panel. It shows the programme selector dial as well as thebuttons, pilot lights a

Available options:Super QuickShort cycle for lightly soiled items or for laundry whichneeds only freshening up. We recommend you to reducethe fabrics

Washing ProgrammesProgramme - Maximum and Minimum Temperature - Cycle De-scription - Maximum Spin Speed - Maximum Fabrics Load -Type of LaundryOptions

Programme - Maximum and Minimum Temperature - Cycle De-scription - Maximum Spin Speed - Maximum Fabrics Load -Type of LaundryOptionsDetergent Compart-

Programme - Maximum and Minimum Temperature - Cycle De-scription - Maximum Spin Speed - Maximum Fabrics Load -Type of LaundryOptionsDetergent Compart-